Transcript DVG-2004S_Setup - D-Link

VoIP ProductsGateway
DVG-2004S
For 2005 D-Link OBU Training
By D-Link PMD Broadband Team
May. 2005
Agenda
•
•
•
•
•
•
•
•
•
•
•
Introduction
Configuration
SIP Setting
Dial Methods
Voice Setting
FXS Module Setting
Gateway Status - Line status etc.
Call Log History
Restore Default
Firmware Upgrading
Implementation
2
Introduction(1/3)
• SIP Protocol(IETF RFC3261)
• Two level web control
• Administrator : login username and password is "
admin"
• General user : login username and password is "
user"
• (only Management / User Setting / Dialing Plan)
• Dial Method:
• Dial IP address without SIP server
• Dial number via SIP server
• Speed Dial (10 sets)
• Codec : G.711u-law , G.711A-law,G.729, G.723
• DTMF : In-Band / Out-Band(SIP INFO/RFC2833)
• NAT Traversal : STUN / UPNP
3
Introduction(2/3)
•
•
•
•
•
•
•
•
Advanced Functions
Hold/Retrieve
Call Transfer(Attended)
Call Forward(No Answer/Busy/Unconditional)
Call Waiting
Anonymous Call / Blocking
Number Display(Caller ID Display/CLIP)
Call History
4
Introduction(3/3) LED Light Display
(1)
No. Label
(2)
(3)
(4)
Display
Status
On
The phone line is active
On
Power on
Flash
System is rebooting
Off
Power off
On
Network connected
Flash
Packet is through this port
On
Network connected
Flash
Packet is through this port
Color
(1)
(2)
(3)
(4)
FXS 1-4
Ready
LAN-Left (100M)
LAN-Right (10M)
Green
Green
Amber
Green
5
Configuration(1/8)
6
Configuration(2/8)
• Execute the windows HyperTerminal application
and use D-SUB 9 pin RS-232 cable to set up
7
Configuration(3/8)
• Check the network status
8
Configuration(4/8)
• Web login : http://ip_address:9999
• Using the Windows Internet Explorer
9
Configuration(5/8)
Management-General Setting
10
Configuration(6/8)User Setting-Network Setting
11
Configuration(7/8) Telnet
12
Configuration(8/8)Telnet
13
SIP Setting(1/3) User Setting-Call Setting
14
SIP Setting(2/3)
Administrator Setting-Sip Setting
15
SIP Setting(3/3)
Administrator Setting-Sip Setting
The fields those must configured
Request - URI: Name displayed on the LCD for the
caller. (it is as same as SIP Display and SIP Request
Name)
Login Name: User name to log in the SIP server.
Password: User password to log in to the SIP server.
Register Server IP Address: SIP Register Server IP
address.
Register Server IP Address Port: Port number of SIP
Register Server.
Outbound Proxy: Outbound Proxy server IP address.
Outbound Proxy Port: Port number of Outbound Proxy
16
Dial Methods(1/5)Dialing Plan-General Setting
17
Dial Methods(2/5)Dialing Plan-Local
18
Dial Methods(3/5)Example : Local table
Mainly for IP call purpose
Prefix: 1
Min Digit: 3
Max Digit: 3
Delete Digit: 0
Ex: 1xx
Add Prefix: 9
Ex: 91xx
Remote IP: 192.168.0.188
Ex: [email protected]
Remote Port: 5060
Ex: [email protected]:5060
19
Dial Methods(4/5)Dialing Plan-URI Phone Book
20
Dial Methods(5/5)Example : URI Phone Book
•
•
•
•
•
•
•
•
•
Index1: 605
Dial method: *#1
Request URI =Sip: 605@registrar
Index2: 192.168.0.168
Dial method: *#3
Request URI =Sip: 192.168.0.168
Index3: [email protected]
Dial method: *#3
Request URI =Sip: [email protected]
21
Voice Setting Administrator Setting-Voice Setting
22
FXS Module Setting(1/2)
Administrator Setting-Port Setting
23
FXS Module Setting(2/2)
FXS connected to Analog phone or Trunk(outgoing) line of PBX
" Phone No" : when the GW doesn' t register,the SIP Display will be
" Phone No"
" Disable" : The purpose of checking the " Disable" box on is for
rejecting an incoming call, it' s a similar function of " Do
Not Disturb" . Once you checking the " Disable" box on,
you' ll always hear a busy tone no matter for the caller
side (not ring back tone) or the self side ( not dial tone).
" Loop Service Type" : support Analog and CID(Caller ID)
" Fxs reverse" : Generate and detect reverse for FXS
" Tone Setting" : The ringing signal and Ring Back Tone will accord to
Country selection
" Caller ID" : support FSK-US / FSK-UK / FSK-JP /DTMF
" Voice Gain" : Transmit and Receive Gain
24
Gateway Status(1/4)Management-Line Status
• To detect the status for each FXS port.
•
IDLE,OFFHOOK,DIAL, DIALING,RING,RINGBACK, TALK
• To detect the Register Status for each FXS port
25
Gateway Status(2/4) Call Log-Event Log
• Call Trace Log is required for debugging and maintenance. (Size of
CTL: 128 lines)
26
Gateway Status(3/4) Call Log-SysLog
27
Gateway Status(4/4)
•
•
•
•
•
•
•
•
•
•
•
•
•
•
DVG-2004S will record system status in system log server
1. System Start
2. System Reboot
3. DSP Fail
4. Uplink Fail
5. Uplink OK
6. Network Fail
7. Network OK
8. SIP Server Fail
9. SIP Server OK
10. DHCP Fail
11. Firmware Upgrading
12. Firmware Upgrade Fail
13.Firmware Upgrade OK
28
Call Log History Call Log-Call Detail Record
29
Restore Default(1/2)
Administrator Setting-Default Setting by web
30
Restore Default(2/2)Administrator SettingDefault Setting by Console /Telnet
•
-Default Setting by Console or Telnet
31
Firmware Upgrade(1/5)ManagementFirmware Upgrade (TFTP server)
32
•
•
•
•
Firmware Upgrade(2/5)ManagementFirmware Upgrade (TFTP server)
TFTP Upgrade
Filling in the blank with a TFTP Server IP
which comprises the desired firmware
edition
Filling in the blank with the desired
firmware edition
Press " Update"
33
Firmware Upgrade(3/5) ManagementFirmware Upgrade (FTP server)
34
Firmware Upgrade(4/5)
Management-Firmware Upgrade (FTP server)
• FTP Upgrade
• Filling in the blank with a FTP Server IP
which comprises the desired firmware
edition
• Filling in the blank with the desired
firmware edition
• Press " Update"
35
Firmware Upgrade(5/5)
Management-Firmware Upgrade
Difference between TFTP and FTP Upgrade
FTP service combines with auto-provisioning
capability
TFTP service upgrades whatever you put
the firmware in TFTP server, even it' s the
same one.
36
4s Gateway implementation with PBX
• A gateway existed between PSTN and IP environment
makes the two-side communication possible
• Hardware configuration: FXS to one external line of PBX,
Ethernet adapter to Internet.
• PSTN-IP =>dial one curtain number which configured by
PBX to hear the dial tone emitted from FXS Module
• IP-PSTN =>use an IP device which registered with the
same server as 4S device to dial to any of the ports of th
is 4S device, then hear an IVR from PBX to get an
indication of dialing numbers to PSTN.
37
SIP Proxy
Station of PBX
PBX
VoIP Gateway
with FXS
IP Phone
IP
Networ
k
IP Phone
PSTN
VoIP Gateway
with FXO
PC
PBX
Network Connection
USB Phone
Station of PBX
Trunk of PBX
Line of PBX
38
Ethereal
• is free
• is used to catch packets
• can be downloaded at
http://www.ethereal.com/distribution/win
32/
39
Ethereal
40
Ethereal
•How to catch packets?
•Run " Ethereal" .
•Click on " Capture" --> " Start ¡"on the menu bar.
•A sub-window pops up.
•Find the " Capture Filter" in the sub-window.
•Type in " host [IP for the device A] | | [IP for the device B] | | [IP for the
server] ..." (eg. host 192.168.60.23 | | 192.168.60.26 | | 192.168.1.1).
•Click on " OK" to start catching the packets.
•Make the same problem happen again
(eg. to make calls from one device to the other).
•The packets are caught on the main screen of Ethereal.
•Click on " Stop" on the tool bar (the red cross) after the problem occurs
(hang up).
41
•Click on " Save" on the tool bar to save the file
Q&A
42