Transcript Schematic-layout

Schematic Diagrams
• Schematic diagrams are used to graphically
represent the components and interconnections
of electrical circuits.
• Electronic schematics consist of symbols that
represent the individual electronic parts used in
the circuit. These symbols are interconnected
with lines that represent the actual electrical
connections.
Preferred Schematic
Diagrams Practices
• A well-drawn schematic makes it easy to
understand how a circuit works and aids in
troubleshooting; a poor schematic only
creates confusion. In order to draw a good
schematic, you should keep the following
suggestions in mind.
General Principles
• Schematics should be unambiguous. Therefore,
pin numbers, parts values, polarities, etc., should
be clearly labeled to avoid confusion.
do
don’t
Rules
• Wires connecting are indicated by a heavy
black dot; wires crossing, but not
connecting, have no dot (don't use a little
half-circular ``jog''; it went out in the 1950s).
do
don’t
Rules (Cont.)
• Four wires must not connect at a point; i.e.,
wires must not cross and connect.
do
Do
don’t
Don’t
Rules (Cont.)
• Always use the same symbol for the same
device; e.g., don't draw flip-flops in two
different ways
• Wires and components are aligned
horizontally or vertically, unless there's a
good reason to do otherwise.
Rules (Cont.)
• Label pin numbers on the outside of a
symbol, signal names on the inside.
• All parts should have values or types
indicated; it's best to give all parts a label,
too, e.g., R7 or IC3.
Hints
• Identify parts immediately adjacent to the
symbol, forming a distinct group giving
symbol, label, and type or value.
do
don’t
Hints (Cont.)
• Signals should flow left to right and in rows
from top to bottom. Orient connectors and
devices in accordance with the signal flow
principle:
– Orient connectors. Input connectors on
the left and output connectors on the right.
– Orient devices. Normal orientation is
with inputs on the left and outputs on the
right, positive power on top, and negative
power or ground at the bottom.
Hints (Cont.)
• Always pointing grounds downward.
do
don’t
Hints (Cont.)
• Put positive supply voltages at the top of the
page, negative at the bottom. Thus, npn
transistors will usually have their emitter at
the bottom, whereas pnp's will have their
emitter topmost.
do
don’t
Hints (Cont.)
• Tie leads together at a single power or
ground object may improve the schematic
layout.
don’t
do
Hints (Cont.)
• Use bus structures to relieve signal
congestion for all data and address signals.
Use labels to implicitly join separated wire
segments together rather than routing the
wires over great lengths.
Hints (Cont.)
don’t
do
Hints (Cont.)
An awful schematic
Hints (Cont.)
A good schematic