Transcript Introduction to Transistors

Transistors
Camille Cruz
Chase Thompson
Tyler Nelson
September 26, 2013
Outline
•
•
•
•
•
•
Introduction
Transistors Types
Bipolar Junction Transistors
Field Effect Transistors
Power Transistors
Example
Transistors
BJT (PNP) Electrical
Diagram
Different types and sizes
FET and BJT Transistor
Modern Electronics
First Transistor
• Purpose
▫ To amplify and switch electronic signals on or off
(high or low)
• Modern Electronics
Microprocessor
Motor Controllers
Cell Phones
Vacuum tubes
• Purpose
▫ Used as signal amplifiers and switches
▫ Advantages
 High power and frequency operation
 Operation at higher voltages
 Less vulnerable to electromagnetic pulses
▫ Disadvantages
 Very large and fragile
 Energy inefficient
 Expensive
Invention
• Evolution of electronics
▫ In need of a device that was small, robust, reliable,
energy efficient and cheap to manufacture
• 1947
▫ John Bardeen, Walter Brattain and William Schockly
invented transistor
• Transistor Effect
▫ “when electrical contacts
were applied to a crystal
of germanium, the output
power was larger than
the input.”
General Applications
Doping
• Process of introducing impure elements
(dopants) into semiconductor wafers to form
regions of differing electrical conductivity
Negatively charged Semiconductor
Positively charged semiconductor
Doping Effects
• P-type semiconductors
▫ Created positive charges, where electrons have
been removed, in lattice structure
• N-type semiconductors
▫ Added unbound electrons create negative charge
in lattice structure
• Resulting material
▫ P-N junction
P-N junction
Forward Biasing
Reverse Biasing
• P-N junction
▫ Controls current flow via external voltage
• Two P-N junctions (bipolar junction transistor,
BJT)
▫ Controls current flow and amplifies the current
flow
Transistor Categories
•
•
•
•
•
•
•
•
Semiconductor material
Structure
Polarity
Maximum power rating
Maximum operating frequency
Application
Physical packaging
Amplification factor
Types of Transistors
• Bipolar Junction Transistor (BJT)
• Field Effect Transistors (FET)
• Power Transistors
BJT Introduction
• Bipolar Junction Transistors (BJT)
consists of three “sandwiched”
semiconductor layers
• The three layers are connected to collector
(C), emitter (E), and base (B) pins
• Current supplied to the base controls the
amount of current that flows through the
collector and emitter
BJT Schematic
• NPN
NPN
▫ BE forward bias
▫ BC reverse bias
• PNP
▫ BE reverse bias
▫ BC forward bias
PNP
BJT Characteristic Curves
Transfer Characteristic
• Characteristic curves can be drawn to show other useful parameters
of the transistor
• The slope of ICE / IBE is called the Transfer Characteristic (β)
BJT Characteristic Curves
Input Characteristic
• The Input Characteristic is the base emitter current IBE against
base emitter voltage VBE
• IBE/VBE shows the input Conductance of the transistor.
• The increase in slope of when the VBE is above 1 volt shows that the
input conductance is rising
• There is a large increase in current for a very small increase in VBE.
BJT Characteristic Curves
Output Characteristic
• collector current (IC) is nearly independent of the collector-emitter
voltage (VCE), and instead depends on the base current (IB)
IB4
IB3
IB2
IB1
BJT Operating Regions
Operating
Region
Parameters
Mode
Cut Off
VBE < Vcut-in
VCE > Vsupply
IB = IC = 0
Linear
VBE = Vcut-in
Vsat < VCE < Vsupply
IC = β*IB
Amplification
Saturated
VBE = Vcut-in,
VCE < Vsat
IB > IC,max, IC,max
>0
Switch ON
Switch OFF
BJT Applications
BJT Switch
• Offer lower cost and substantial reliability over conventional
mechanical relays.
• Transistor operates purely in a saturated or cutoff state (on/off)
• This can prove very useful for digital applications (small current
controls a larger current)
BJT Applications
BJT Amplifier
BJT Applications
BJT Amplifier
Field Effect Transistors (FET)
Chase Thompson
FET Basics
• Electric Field
• Voltage Controlled
• FET includes three distinct pieces
▫ Drain
▫ Source
▫ Gate
FET versus BJT?
Same:
• Applications: amplifier,
switch, etc.
• Relies on PNP or NPN
junctions to allow current
flow
Difference:
• Voltage vs Current Input
• Unipolar vs Bipolar
• Noise
• Higher input impedance
• Fragile and low gain bandwidth
Types of Field-Effect
Transistors
Type
Function
Junction Field-Effect Transistor
(JFET)
Metal-Oxide-Semiconductor FET
(MOSFET)
Insulated Gate Bipolar Transistor
(IGBT)
Similar to MOSFET, but different main channel
Organic Field-Effect Transistor
(OFET)
Uses organic semiconductor in its channel
Nanoparticle Organic Memory FET (NOMFET)
Uses reversed biased p-n junction to separate gate from body
Uses insulator (usu. SiO2) between gate and body
Combines the organic transistor and gold nanoparticles
JFET
• Reverse Biased PNjunction
• Depletion mode devices
▫ Creates a potential
gradient to restrict
current flow. (Increases
overall resistance)
http://www-g.eng.cam.ac.uk/mmg/teaching/linearcircuits/jfet.html
JFET
• N-channel JFET
• P-channel JFET uses same principles but
▫ Channel current is positive due to holes instead of
electron donors
▫ Polarity of biasing voltage must be reversed
N-Type Characteristics
Characteristics and Applications of FETs
JFETs
•
•
•
•
•
Simplest type of FET – easy to make
High input impedance and resistance
Low Capacitance
Slower speed in switching
Uses?
– Displacement sensor
– High input impedance amplifier
– Low-noise amplifier
– Analog switch
– Voltage controlled resistor
MOSFET
p-channel
• Similar to JFET
▫ A single channel of single doped SC
material with terminals at end
▫ Gate surrounds channel with doping that
is opposite of the channel, making the
PNP or NPN type
▫ BUT, the MOSFET uses an insulator to
separate gate from body, while JFET uses
a reverse-bias p-n junction
n-channel
MOSFET
enhanced mode
MOSFET
depleted mode
How does a MOSFET work?
No Voltage to Gate
Source
Voltage to Gate
Drain
Source
Drain
n
n
Simplified Notation
No current flow
“Short” allows current flow
MOSFET
Triode Mode/Linear Region
Saturation/Active Mode
VGS > Vth and VDS < ( VGS - Vth )
VGS > Vth and VDS > ( VGS - Vth )
VGS : Voltage at the gate
Vth : Threshold voltage
VDS : Voltage from drain to source
μn: charge-carrier effective mobility
W: gate width
L: gate length
Cox : gate oxide capacitance per unit area
λ : channel-length modulation parameter
Characteristics and Applications of FETs
MOSFETs
•
•
•
•
Oxide layer prevents DC current from
flowing through gate
• Reduces power consumption
• High input impedance
Rapid switching
More noise than JFET
Uses?
• Again, switches and amplifiers in
general
• The MOSFET is used in digital
CMOS logic, which uses p- and nchannel MOSFETs as building
blocks
• To aid in negating effects that cause
discharge of batteries
Use of MOSFET in battery
protection circuit
Power Transistors
 Concerned with delivering high power
 Used in high voltage and high current application
In general
Fabrication process different in order to:
 Dissipate more heat
 Avoid breakdown
Different types: Power BJTs, power MOSFETS, etc.
Comparison
Property BJT
MOSFET JFET
Gm
Best
Worst
Medium
Speed
High
Medium
Low
Noise
Moderate
Worst
Best
Good
No
Switch
High-Z Gate No
Yes
Yes
Yes
Yes
ESD
Sensitivity
More
Less
Less
References (32)
1.
2.
3.
4.
5.
6.
7.
8.
9.
10.
11.
12.
13.
14.
15.
16.
17.
18.
19.
20.
21.
22.
23.
24.
25.
26.
27.
28.
29.
30.
31.
32.
http://www.utdallas.edu/research/cleanroom/TystarFurnace.htm
http://www.osha.gov/SLTC/semiconductors/definitions.html
http://www.products.cvdequipment.com/applications/diffusion/1/
http://amath.colorado.edu/index.php?page=an-immersed-interface-method-for-modeling-semiconductor-devices
http://www.extremetech.com/article2/0,2845,1938467,00.asp
http://macao.communications.museum/eng/Exhibition/secondfloor/moreinfo/2_10_3_HowTransistorWorks.html
http://fourier.eng.hmc.edu/e84/lectures/ch4/node3.html
http://www.appliedmaterials.com/htmat/animated.html
http://hyperphysics.phy-astr.gsu.edu/hbase/solids/dope.html#c3
http://www.tpub.com/neets/book7/25.htm
http://esminfo.prenhall.com/engineering/wakerlyinfo/samples/BJT.pdf
http://web.engr.oregonstate.edu/~traylor/ece112/lectures/bjt_reg_of_op.pdf
http://www.me.gatech.edu/mechatronics_course/transistors_F09.ppt
http://en.wikipedia.org/wiki/Bipolar_junction_transistor
http://en.wikipedia.org/wiki/Common_emitter
http://en.wikipedia.org/wiki/Diode
http://www.kpsec.freeuk.com/trancirc.htm
http://en.wikipedia.org/wiki/Field-effect_transistor
http://en.wikipedia.org/wiki/JFET
http://en.wikipedia.org/wiki/MOSFET
http://www.slideshare.net/guest3b5d8a/fets
http://www.rhopointcomponents.com/images/jfetapps.pdf
http://cnx.org/content/m1030/latest/
http://www.play-hookey.com/semiconductors/enhancement_mode_mosfet.html
http://www.youtube.com/watch?v=-aHnmHwa_6I&feature=related
http://www.youtube.com/watch?v=v7J_snw0Eng&feature=related
http://info.tuwien.ac.at/theochem/si-srtio3_interface/si-srtio3.html
http://hyperphysics.phy-astr.gsu.edu/hbase/solids/dope.html#c4
http://inventors.about.com/library/inventors/blsolar5.htm
http://thalia.spec.gmu.edu/~pparis/classes/notes_101/node100.html
http://hyperphysics.phy-astr.gsu.edu/hbase/solids/pnjun.html#c3
http://science.jrank.org/pages/6925/Transistor.html
Questions?