Transcript Advantys STB - Schneider Electric

Advantys STB
TM ©
Functional Demo Kit
Advantys STB
Advantys STB TM ©
Functional Demo Kit
Advantys STB
What is the Functional Demo Kit ?




The Functional Demo kit is being made available
for marketing, training, customer demonstrations
and support. Part Number: STB XSM 4800
The kit is supplied with a fully functional Advantys
STB I/O system with an Ethernet Network
Interface. Also includes a fully functional licensed
version of the Advantys configuration software
and serial cable.
The kit comes in a hard shell plastic molded water
tight case and has pre-located mounting screws
to support a 4 slot Premium, Quantum PLC or
additional DIN rails for a Momentum PLC .
A PLC is not included.
Advantys STB
What are the technical specs?





Functional Demo Kit is pre-wired and tested with 8
digital input buttons , 8 digital outputs lamps , an analog
input simulator potentiometer -10 / +10 v and an
analog output meter -10 / +10 v .
The input ( Switched IEC type cord receptacle )
voltage is 110 – 230 VAC. An auto-sensing 2 Amp DC
power supply is installed to power the Advantys STB
system as well as auxiliary devices.
An auxiliary service outlet is provided for a PC – US
type grounded.
A separate switch is provided for the AC power and the
DC power .
The cover has a compartment for cables and
paperwork and is removable to allow upright placement
of the case on a table.
Actual modules supplied with the Demo Kit?
Advantys STB
Qty
Model Number
Vendor
Description
1
STB DDI 3230
Telemecanique/SqD
24VDC IN 2pt sink 4wire 0.2ms cfg SCP
1
STB DDI 3420
Telemecanique/SqD
24VDC IN 4pt sink 3wire 0.5ms cfg SCP
1
STB DDI 3610
Telemecanique/SqD
24VDC IN 6pt sink 2wire 1ms fixed
1
STB DDO 3200
Telemecanique/SqD
24VDC OUT 2pt source 0.5A OCP
1
STB DDO 3230
Telemecanique/SqD
24VDC OUT 2pt source 2.5A OCP
1
STB DDO 3410
Telemecanique/SqD
24VDC OUT 4pt source 0.5A OCP
1
STB DDO 3600
Telemecanique/SqD
24VDC OUT 6pt source 0.5A OCP
1
STB AVI 1270
Telemecanique/SqD
Analog V IN 2ch 11bit iso 0...+/-10V
1
STB AVO 1250
Telemecanique/SqD
Analog V OUT 2ch 11bit 0...+10V
1
STB NIP 2212
Telemecanique/SqD
Ethernet MB TCP/IP NIM standard
Advantys STB
What does it look like ?
Receptacle,
Switch
simulator
panel
Plastic
Molded
Case
Latched
Cable and
Document
holder
Removable Top
cover with hinge
pins
Mounting
area for
PLC or
other
devices
DC power supply and
all cables are below
aluminum plates
Advantys STB
What are the features ?
Pre-wired and
tested
Advantys STB
System
Quantum
PLC
Mounting
Screws
8 maintained
lighted
switches
Premium
PLC
mounting
Screws
Service
Receptacle
IEC AC
Switched Power
Input
Receptacle
DC Power
Switch
Pre-wired AC
power ready
For PLC
-10/+10V
Meter
-10/+10V
Potentiometer
Advantys STB
A Quantum PLC Installed
Pre-wired AC
power and PE
wired to the PLC
Advantys STB
A Premium PLC Installed
Pre-wired AC
power and PE
wired to the PLC
Advantys STB
How to remove the cover
Remove Hinge
Pins 2 placestwist and pull.
Lift cover off.
Advantys STB
How to open the inside cable
and document compartment
Pull Out (snap)
to release.
Push (snap) down
to lock
Advantys STB
How is it wired?







It is pre-wired with each switch connecting to one
channel on a digital input module.
Each lamp is connected to a separate output channel.
The analog input potentiometer is connected to the first
channel of the analog input module.
The analog meter is connected to the first channel of
the output module.
The second channel of the analog modules are tied
together in a loop-back circuit.
Some additional digital outputs are tied to spare input
channels in a loop-back circuit.
For more details see the Attached document.
Advantys STB
What are the component
designations and locations?
Mounted DIN rail
Up to a 12 I/O module System
PS1
M3
This panel should be enclosed
with minimal exposed wiring –
Internal to this box is a 1.5 amp auto
sensing input 120/230 v24VDC output Power Supply –
M1
M2
M5
M4
M7
M6
M9 M11
M8
M10
S1
S2
S3
S4
S5
S6
S7
S8
L1
L2
L3
L4
L5
L6
L7
L8
PLC1
ACR1
AC Receptacle
For PC /Aux Equipment
Main AC
Power Switch W/
Receptacle
SFR1
AM1
S9
Analog meter
DC
Power Switch
P1
pot
Lighted -Switches 8 maintained push buttonsAll Switches also have illumination internally .
24 VDC
Panel drilled and tapped
W inserts for mounting of either
Quantum or Premium 4 slot rack
Advantys STB
Analog input Simulator
Use ¼ watt resistors and potentiometer
Max output current = 0.014 A
Max voltage output = 10.95