J Holton TG 360 SP0 169 UPDATE Summary of TG 360 Status
Download
Report
Transcript J Holton TG 360 SP0 169 UPDATE Summary of TG 360 Status
NACE EASTERN AREA
CONFERENCE
TG 360 SP0 169 UPDATE
Summary of TG 360 Status
STG 35 Balloting Pool has 315 STG
member voters plus
76 others for a total pool of
391.
Ballot closed out September 1,
2009 with 70% of eligible voters
submitting ballots. (minimum
required is 50%).
The STG Affirmative Vote was 124 or
65.4% (excluding abstaining [34])
A 2/3 vote or 66 2/3% is required to
proceed with the document to
consider and resolve negative votes.
The ballot had a total of 112 of
the 270 balloters submitting
comments
Affirmative(35),
Negative(74)
Abstain(3).
The Task Group 360 members
(now 21) will now review all the
comments and consider changes
to the document to address these
comments.
TG 360 must go back
and work the document
and go out again for a ballot!
The Task Group is not
resolving negatives.
The target
is to be out for ballot by January 2,
2010
and be addressing any negatives
during Corrosion 2010 in
San Antonio, Texas March 16th.
SOME COMMENTS RECEIVED
Comments can be viewed by going to
the NACE website
“Committees”
“Online Balloting”
“Results” ( on page 9 of Results)
“Text Comments”
and “File Comments”.
Some that say they use 850 On and only have
leaks where they are not protected
There are some that it is very apparent that they
use 850 On and no consideration for voltage
drop which is not in compliance with any of
the criteria
There are some negatives that discuss
references, a good one is definition of HVAC as
heat, ventilating and air conditioning
6.2.4.1.1 The word “corrected” is
not adequate without further
clarification. I believe that this
section should remain as is with
IR "considered".
All of our leaks are caused by
lack of adequate cathodic
protection, shielding affects,
interference, outside forces or
internal corrosion. I suggest that
you leave the -.85mV current
applied criteria as is.
Negative 8/31/2009 I want to
thank the committee for their
hard work on this issue.
SPECIALTY POLYMER COATINGS USA INC
Jerry Holton
11225 State Route 90
Locke, NY 13092
Office: 315-497-1528
Cell: 315-283-3906