Transcript SKM_Presentation

SKM SOFTWARE
 SKM Software is used for creating ARC Flash labels
 The current version is: (6.5.2.7 Build 2)
 An arc flash is an electric arc which can occur when
there is sufficient voltage in an electrical system and a
path to ground or lower voltage.
An arc flash with 1000 amps or more can cause
substantial damage, fire or injury. The massive energy
released in the fault rapidly vaporizes the metal
conductors involved, blasting molten metal and
expanding plasma outward with extreme force.
PRINTING FROM SKM
 BRADY TECH SUPPORT CAN ASSIST WITH:
 SELECTING THE PROPER SIZE TEMPLATE
 THE PRINT FUNCTION OF SKM SOFTWARE
 CONFIGURING THE BRADY PRINT DRIVER
 THE ONLY BRADY PRINTERS SUPPORTED ARE :
 IP’s, PR+’s, GLOBALMARKS
 BBP31 & MINIMARK ARE CURRENTLY NOT SUPPORTED
FOR USE WITH SKM SOFTWARE
CURRENT VERSIONS OF
SKM SOFTWARE OPEN
WITH THIS SCREEN
START BY CLICKING
RUN
ON THE TOOLBAR
SELECT
ARC FLASH EVALUATION
THIS IS THE
NEXT SCREEN
YOU WILL SEE
CLICK ON
CUSTOM LABEL
THIS IS THE
NEXT SCREEN
YOU WILL SEE
CLICK THE DROP DOWN
LIST TO VIEW
DIFFERENT LABEL TYPES
THT PART NUMBERS ARE FOR USE
WITH THE IP & PR+ PRINTERS
GLOBALMARK LABELS SHOW
GLOBALMARK
SELECT THE
DESIRED LABEL
YOU WILL SEE A PREVIEW
OF YOUR SELECTED LABEL
CLICK ON “DESIGNER”
USE THE DESIGNER SCREEN TO
VERIFY PAGE SIZE, LABEL SIZE & ORIENTATION
SIZE MUST MATCH THE INSTALLED LABEL
CLICK “OK” AFTER SETUP IS COMPLETE
YOU CAN NOW
SELECT PRINT
SELECT CONTINUE TO PRINT
THE PRINT SCREEN NOW COMES UP
CLICK THE DROP DOWN LIST TO SELECT
THE BRADY PRINTER TO USE
ONCE THE PRINTER IS SELECTED
CLICK THE PROPERTIES BUTTON
CLICK PAPER SIZE: PROPERTIES
TO VERIFY THE SIZE SETTINGS
FOR THT PRINTERS
PAPER SIZE = USER
SENSOR TYPE = GAPPED
GAP SPACE = 0.1 Inches
PAPER WIDTH & HEIGHT SHOULD
MATCH THE DIMENSIONS OF THE
LABEL INSTALLED IN THE PRINTER
FOR THT PRINTERS
TAPE TYPE = THERMAL
TRANSFER
PRINT SPEED = 2 INCH
DENSITY = 0-10
PRINT MODE = TEAR OFF
FOR GLOBALMARK PRINTERS
SELECT THE GLOBALMARK
THEN CLICK ON PROPERTIES
FOR GLOBALMARK PRINTERS
SET ORIENTATION TO LANDSCAPE
IF ADVANCED TAB IS AT THE TOP = SELECT IT
IF ADVANCED BUTTON IS AT BOTTOM= SELECT IT
FOR GLOBALMARK PRINTERS
CLICK ON PAPER SIZE
THEN CLICK ON PROPERTIES
FOR GLOBALMARK PRINTERS
TAPE SIZE MUST MATCH WHATS
INSTALLED IN THE PRINTER
SET THE DOCUMENT LENGTH TO
YOUR DESIRED LENGTH
AFTER MAKING CHANGES, CLICK OK
TO CLOSE OUT OF PROPERTIES
SELECT “OK” TO PRINT
EXAMPLE OF A GLOBALMARK PART
THIS HEADER WILL PRINT
EXAMPLE OF A THT PART WITH
PRE-PRINTED HEADER
PRE-PRINTED
HEADER SHOWS UP
HERE WHEN IT
PRINTS
WE OFFER LIMITED SUPPORT
OF SKM SOFTWARE
THE FOLLOWING KBASE ARTICLES ARE A GOOD
RESOURCE FOR PROVIDING TO CUSTOMERS:
4347
3829
3814
3058
4276 & 5017
– PR300+ PRINTER
– THT PRINTERS
– BRADY PRINTERS
– GLOBALMARK PRINTERS
– IP PRINTERS
FOR QUESTIONS ON SOFTWARE USAGE, CUSTOMERS
CAN FIND SKM CONTACT INFORMATION USING THIS LINK:
 http://www.skm.com/tech_support.shtml