Transcript hotEx-RADIUS-Manager-Installation-Guide

hotEx Radius Manager
Installation
hotEx RADIUS Manager Network Diagram
Client PC
Connect client PC connection diagram
192.168.1.XX
192.168.1.55
192.168.1.XX
Note:
Use WAN IP Address (Public Static IP), when you configure
the Hotspot Client Gateway
Note:
If the ‘hotspot location’ does not have a Public Static IP
number or domain name, you may enter “ 0.0.0.0/0 ”.
HotSpot Client Gateway Installation
HotSpot Client Gateway Network Diagram
Installing hotspot client gateway
You are now going to convert Linksys router as a hotspot client
gateway, using the Laptop/PC.
Switch On the Linksys router.
Ensure the WiFi network adapter of the Laptop/PC is enabled and
working, and set it in DHCP Mode (i.e., ‘Obtain IP Address
automatically) as shown below.
After Setup the Linksys, Open the browser (e.g.: Internet Explorer) and enter the ip
“192.168.1.1”. You will see the login prompt. Type the User name and Password
(default password is admin) and Click Ok.
After 3-4 minutes, you will see the message “Upgrade Successfully”. (It is very
important to wait for this message. Do not go further until you see this message),
Click Continue.
Note:
After installing the configuration files the Hotspot client
Gateway will be automatically rebooted.
Enter your hotEx RADIUS Manager Server
IP address. Preferably, this would be a
Public Static IP
Enter your hotEx RADIUS Manager Server
IP address. Preferably, this would be a
Public Static IP
The shared key highlighted in this screen,
must be the same, with the menu of "hotEx
RADIUS Manager -> HOME -> ADD NAS > NAS Client Location -> SECRET"
Enter your hotEx RADIUS Manager Server
IP address. Preferably, this would be a
Public Static IP
When the hotEx RADIUS is ready, you would have assigned an IP from it. To confirm, please go to Start  Run  Type “cmd”
 Type “ipconfig”. To make double-confirmation on the IP assignment, you can use the dos commands “ipconfig /release” and
“ipconfig /renew”
Now, you are logged in successfully and you
can start using Internet
To logout, please enter “ http://exit ” or “
http://logout ” in the browser.