Transcript How-to-Install-hotEx-RADIUS-Manager-and

hotEx RADIUS Manager
Installation
hotEx RADIUS Manager Network Diagram
Client PC
Connect client PC connection diagram
192.168.1.XX
192.168.1.55
192.168.1.XX
192.168.1.XX
Note:
WAN IP Address can be private IP, if the hotspot client gateway (or the location
router) is also in the same subnet.
WAN IP Address can be public static IP address, if you plan for multiple hotspot
locations
Note:
If the 'hotspot location' (or the location router) is NOT
assigned to any Public Static IP (or domain name), you may
enter 0.0.0.0/0 as indicated above.
HotSpot Client Gateway Installation
System Requirements
Hardware requirement
•LinkSys WiFi Router (Model WRT54GL)
•Laptop/PC (for initial setup only)
Software requirement
192.168.1.XX
•Openwrt Firmware
•Configuration file
You are going to connect LinkSys Router with the Laptop/PC through WiFi. No other software or
Operating System is necessary.
Note:
Please download the below firmware and configuration files and keep them in your desktop for
further use.
http://hotspotexpress.in/ispot/openwrt-wrt54g-squashfs.bin
http://hotspotexpress.in/ispot/config.tgz
HotSpot Client Gateway Network Diagram
192.168.1.XX
LAN PORT
192.168.1.1
Installing hotspot client gateway
You are now going to convert Linksys router as a hotspot client
gateway, using the Laptop/PC.
Switch On the Linksys router.
Ensure the WiFi network adapter of the Laptop/PC is enabled and
working, and set it in DHCP Mode (i.e., ‘Obtain IP Address
automatically) as shown below.
After Setup the Linksys, Open the browser (e.g.: Internet Explorer) and enter the ip
“192.168.1.1”. You will see the login prompt. Type the User name and Password
(default password is admin) and Click Ok.
After 3-4 minutes, you will see the message “Upgrade Successfully”. (It is very
important to wait for this message. Do not go further until you see this message),
Click Continue.
Note:
After installing the configuration files the Hotspot client
Gateway will be automatically rebooted.
HotSpot Client Gateway Network Diagram
(after the firmware and config file are uploaded and rebooted)
WAN PORT
192.168.1.197 or
192.168.1.198 or
192.168.1.199
192.168.1.XX
LAN PORT
192.168.100.1
192.168.100.XX
Enter your hotEx RADIUS Manager Server
IP address. Preferably, this would be a
Public Static IP
Enter your hotEx RADIUS Manager Server
IP address. Preferably, this would be a
Public Static IP
The shared key highlighted in this screen,
must be the same, with the menu of "hotEx
RADIUS Manager -> HOME -> ADD NAS > NAS Client Location -> SECRET"
Enter your hotEx RADIUS Manager Server
IP address. Preferably, this would be a
Public Static IP
When the hotEx RADIUS is ready, you would have assigned an IP from it. To confirm, please go to Start  Run  Type “cmd”
 Type “ipconfig”. To make double-confirmation on the IP assignment, you can use the dos commands “ipconfig /release” and
“ipconfig /renew”
Now, you are logged in successfully and you
can start using Internet
To logout, please enter “ http://exit ” or “
http://logout ” in the browser.