Transcript exp2x

Switch Commands
Exec Commands
Switch#?
exec Commands
clear
configure
copy
disabled
enable
erase
exit
logout
ping
reload
Dr. Faisal Yousef Alzyoud
Reset functions
Enter configuration mode
Copy from one file to another
Turn off privileged commands
Turn on privileged commands
Erase a file system
Exit from the EXEc
Exit from the EXEc
Send echo messages
Halt and perform a cold restart
1
show
Show running system information
trace
Trace route to a destination
write
Write running configuration to memory, network or terminal
Config Commands
Configure commands
cdp
Global CDP configuration subcommands
enable
Modify enable password parameters
end
Exit from configure mode
exit
Exit from configure mode
host name
Set System’s network name
interface
Select an interface to configure
ip
Global IP configuration subcommands
line
configure terminal line
no
Negate a command or set its default
vlan
Vlan commands
Dr. Faisal Yousef Alzyoud
2
Interface Commands
Switch (configure-if#)?
cdp
Global CDP configuration subcommands
description
Interface specific description
duplex
Configure duplex operations
exit
Exit from interface configuration mode
mac-address
Manually set interface MAC address
no
Negate a command or set its default
shutdown
Shutdown the selected interface
speed
Configure speed operations
switchport
Set switch mode characteristics
Dr. Faisal Yousef Alzyoud
3
Routers Commands
Exec Commands
exec Commands
clear
configure
copy
debug
disabled
enable
erase
exit
logout
no
ping
reload
Dr. Faisal Yousef Alzyoud
Reset functions
Enter configuration mode
Copy from one file to another
Debugging functions
Turn off privileged commands
Turn on privileged commands
Erase a file system
Exit from the EXEc
Exit from the EXEc
Disable debugging informations
Send echo messages
Halt and perform a cold restart
4
show
Show running system information
trace
Trace route to a destination
undebug
Disable Debugging functions
write
Write running configuration to memory, network or terminal
Configure Commands
access-list
Add access list entry
cdp
Global CDP configuration subcommands
enable
Modify enable password parameters
end
Exit from configure mode
exit
Exit from configure mode
host name
Set System’s network name
interface
Select an interface to configure
ip
Global IP configuration subcommands
line
configure terminal line
no
Negate a command or set its default
router
Enable a routing process
username
Establish User Name Authentication
Dr. Faisal Yousef Alzyoud
5
Router Interface Commands
Router (configure-if#)?
bandwidth
Set bandwidth information parameters
cdp
CDP interface subcommands
clock
Configure serial interface clock
delay
Specify interface throughput delay
description
Interface specific description
encapsulation
Set encapsulation type for an interface
exit
Exit from interface configuration mode
frame-relay
Set frame relay parameters
ip
Interface Internet Protocol config commands
keepalive
Enable keepalive
no
Negate a command or set its default
ppp
Point-to-Point Protocol
shutdown
Shutdown the selected interface
Dr. Faisal Yousef Alzyoud
6
Dr. Faisal Yousef Alzyoud
7
Simulate the following topology using your assumption for IP addresses.
Dr. Faisal Yousef Alzyoud
8