CISCO ROUTER

Download Report

Transcript CISCO ROUTER

CISCO ROUTER
BY
Mark Sullivan
Nancy Tung
Xiao Yan Wu
Agenda
Cisco Background
 What is a Router
 What is Switch
 Router Command
 Router Configuration

Cisco Background

The worldwide leader in
networking for the Internet.

Internet Protocol-based (IP)
networking solutions

provides the broadest line of
solutions for transporting data,
voice and video
Cisco Security





Cisco equipment ensure that
networks both public and
private
operate with maximum
performance
flexibility security
VPN (Virtual Private Network)
Encryption
Remote Office
Router




A router is located at the gateway
it routes packets as they travel from one
network to another network(s).
A router can be either a hardware device
or a software application
The router is connected to at least two
networks
Cisco 4000
Router Interfaces
The console port is a management port used to provide out-of-band access to
the router. It is used for the initial configuration of the router, monitoring, and
disaster recovery procedures.
To connect to the console port, a rollover cable and a RJ-45 to DB-9 adapter are
used to connect a PC. Cisco supplies the necessary adapter to connect to the
console port.
Switches



segments the Local Area
Network (LAN)
by directing the data flow and
determines the route of packets
a switch performs the layer 2 or
Data-Link layer function.
Switch Interface
Switch Port Connections
Router Connection


To connect the PC to a router:
Configure terminal emulation software on the PC
for:
 The appropriate com port
 9600 baud
 8 data bits
 No parity
 1 stop bit
 No flow control

Connect the RJ-45 connector of the rollover cable to
the router console port.

Connect the other end of the rollover cable to the
RJ-45 to DB-9 adapter.

Attach the female DB-9 adapter to a PC.
Connect the Console Cable




1. Connect the light-blue console cable to the light-blue port labeled CONSOLE on the
rear panel of the router.
2. Connect the other end of the light-blue console cable to an RJ-45 adapter.
Use either the RJ-45-to-DB-9 adapter or the RJ-45-to-DB-25 adapter, depending on
your local terminal or PC.
3. Attach the adapter to a serial port on a terminal or PC running emulation software
to allow router configuration.
Connect Ethernet
Two Router Configuration
Main Office
Home Office
Network Connections
Office
Home
Office in
Home
Servers
Bedroom
Connection
Router Basic Topology
Network Configuration Modes
Hostname Command
Router#hostname HomeOffice
HomeOffice(config)#
Configuration Commands
Interface Commands
Interface Commands
Router Protocol Command
HomeOffice#router rip
network ip address
network
ip address
Summary
Cisco Routers technology links
many of the worlds
communication networks.
Cisco.com
Cisco Academy
http://cisco.netacad.net
2600 Router
6500 Switch