Transcript BCI IEEE - Airports Authority of India

Basic Commerce and Industries, Inc.
Systems and Software Engineering
BCI’s
Aeronautical
Telecommunication
Network
(ATN)
Router
BCI ATN Router
General Capabilities
• BCI’s ATN Router is a Class 4 ATN router in accordance
with ICAO Doc 9705
•
Support all ATN OSI protocols: IDRP, CLNP, ES-IS, and
IS-IS
•
Support ISO 8208 (X.25) and ISO 8802 (Ethernet)
•
Support IPv4 and IPv6 SNDCFs
BCI Systems and Software Engineering
Aviation Systems
BCI ATN Router
Operating Environment
• BCI’s ATN Router runs natively on any Intel-based
processor
•
Under LINUX Operating System
•
Have delivered systems on Dell Power Edge Rack
Mount System and HP Servers
•
Use Performance Technology 4-port card for X.25 WAN
interface
•
Can be configured for redundant operation with a system
controlled front-end switch
BCI Systems and Software Engineering
Aviation Systems
BCI ATN Router
User Interface
• Router has Graphical User Interface (GUI)
– Intuitive and
– Not dependent on Operating System or User Terminals
BCI Systems and Software Engineering
Aviation Systems
BCI ATN Router
Configuration
• Easily configured through Configuration and Adaptation
Tool
# Start the BIS-2 neighbor system record
#
SYS BIS-2
#
# Set the Network Address (NSAP)
#
NET 20 4700278185555300020202020200000001010100
#
# Define the destination subnetwork Address for this neighbor
#
ETH 00 12 00076b3d652c
#
# Define the local interface used to reach this neighbor
#
LINK ETH 00 TO ETH 00
#
# Define the IDRP Policy to be used with this neighbor system
#
PD_POLICY INTRA_REGIONAL_POLICY
#
# Terminate BIS-2 Neighbor System Record
#
END_SYS
BCI Systems and Software Engineering
Aviation Systems
BCI ATN Router
Other Features
•IDRP Security in accordance with Doc 9705 Edition 3
• Can operate without a PKI using pre-shared keys
• TCP/IP (RFC 1006) to TP4/CLNP Gateway
• For AMHS Systems which only have AMHS over
TCP/IP
• Could also be used for AIDC to have dual-stack
capability
BCI Systems and Software Engineering
Aviation Systems
Air/Ground Application Support
• BCI’s Ground-Ground Router also supports Air-Ground
Application Routes
• Support Air-Ground Routing Policy based on IDRP
attributes to signal Traffic Type
• Can be used as Backbone for Air-Ground Traffic
-Support 10,000 Air-Ground Routes
• BCI is currently developing an Air-Ground Router
• Will support Mobile SNDCF, VDL-2 Packet Level
Procedures, and VDL-2 Handoff Across VDL
Ground Stations
• Will complete in 2nd Quarter 2009
BCI Systems and Software Engineering
Aviation Systems
BCI ATN Router
Contact Information
• For AMHS BCI’s Teaming Partner is COMSOFT, GmbH
• For ATN products, engineering support, or training,
contact
– Tom McParland, VP, Aviation Systems Division
• Telephone: 609-425-4410
• E-mail: [email protected]
BCI Systems and Software Engineering
Aviation Systems