Transcript 30312022 TR41 Presentation on IP Network Model 11-10

Analyze
Assure
Accelerate
Network Model for Evaluating Multimedia
Transmission Performance Over Internet Protocol
PN-3-0062
Will become TIA/EIA-921
Jack Douglass, Spirent
Chair TIA TR30.3
November 10, 2003, TIA TR41
TR30.3 30312022
TR41.4-03-11-060-L
[email protected]
Purpose of Presentation
• Establish a formal liaison between TR30.3 and TR41 to help
develop Network Model for Evaluating Multimedia Transmission
Performance Over Internet Protocol (PN-3-0062)
• Other Liaisons Activities
–
–
–
–
ITU-T SG15 Questions 5, 6, 7
ITU-T SG16 Question
IETF
Etc.
• Invite TR41 members to TR30.3 meetings to work on IP Network
Model
– IP Network Statistics
– Network Architecture
– Test Scenarios
TR30.3 Modem Test Standards
• TIA/EIA 496A-1989: Interface Between Data Circuit Terminating
Equipment (DCE) and the Public Switched Telephone Network
– Included Network Model for Evaluating Modem Performance
• TIA/EIA TSB 37A-1994: Telephone Network Transmission Model
for Evaluating Analog Modem Performance, which became ITU-T
Recommendation V.56bis-1995
• EIA/TIA TSB 38-1994: Test Procedures for Evaluation of 2-Wire 4
Kilohertz Voice Band Duplex Modems, which became ITU-T
Recommendation V.56ter-1996
• ANSI/TIA/EIA 3700-1999: Telephone Network Transmission
Model for Evaluating Analog Modem Performance
• ANSI/TIA/EIA 793 -2000: North American Telephone Network
Transmission Model for Evaluating Analog Client and Digitally
Connected Server Modems
• ANSI/TIA 876 – 2002: North American Network Access
Transmission Model for Evaluating xDSL Modem Performance
Network Model Coverage (NMC) Methodology
• Waterfall Curves
– Traditional method of measuring modem performance
– Error rate measured against single impairments such as Gaussian noise
– Severe stress conditions
• Network Model Coverage (NMC)
– Introduced by TR30.3 in TIA/EIA-1992 TSB37
– Network Model is a portrait of the real network
– Statistically based Network Model -- Likelihood of Occurrence (LOO) of a given
connection
– Modem performance evaluated using a Impairment Combinations and Local
Loop Combinations
– Curve showing Percentage of Network Model Vs Throughput
• Estimates percentage of network of the real network over which the modem can be
expected to operate
– Compare performance of different models or manufactures of modems
– Network Model is independent of modem technology
Network Model for Evaluating Multimedia
Transmission Performance -- PN-3-0062
Converged Network Reference Model Diagram
TE
A Telco D
Gateway
Switch
L
IP Network
L
TE
A Telco D
Gateway
Switch
TIA-793 Network Model
TIA-793 Network Model
R,G,S*
Gateway
L
L
R,G,S*
R,G,S*
Gateway
Test Scenario:
PSTN to PSTN connections through a
managed IP network
Test Scenario:
PSTN – IP connections
Test Scenario:
IP – IP connections
Examples of Communication Equipment that
can be tested over the Converged Network
Model
• IP Network Devices such as User Agents, Call Agents,
•
•
•
•
•
•
Media Servers, Media Gateway Controllers,
Gatekeepers, Application Servers, Edge Routers,
Gateways
Plain Old Telephone Service (POTS) and IP telephones
Voice-over-IP (VoIP) gateways
ITU-T V-series data modems, both analog client and
digitally connected server
T.30 and T.38 facsimile devices and gateways
V.150.1 and voiceband data (VBD) modem-over-IP
gateways
TIA-1001 (and V.toip) textphone-over-IP gateways
Test Voice, Fax or Data over IP
using Converged Network Model
IP
Simulator
Analog PSTN
Analog PSTN
Simulator 2
Simulator 1
Voice, Video,
Data, Fax, etc.
Gateway
Gateway
Voice, Video,
Data, Fax, etc.
Test IP Network Devices using IP
Network Model
IP
Simulator
IP Network
Devices
IP Network
Devices
Example of Test Profile with Fixed
Values of Network Impairments
Impairment Type
Units
Range
Jitter
ms
+/- 75
One Way Latency
ms
50 to 150
Sequential Packet Loss
#sequential packets losses
0 to 3
Rate of Sequential Loss
sec-1
< 10-3*
Random Packet Loss
%
0 to 2
Out of Sequence Packets
%
0 to 10-1**
• Network Impairments Conditions could be based on set of
impairment combination that have fixed values
– Stress IP Network Device
• Impairments on a real IP Network are not fixed
Parameters that Need to be Considered
when Simulating an IP Network
•
•
•
•
•
•
•
•
•
•
Network Architecture
Types of Access Links
QoS controlled Edge Routing
Route Flapping
Link Failure
Load Sharing
Time Drift
MTU Size
Background Traffic
One Way Delay
Packet Delay
Example of Test Profile with Time
Variable Network Impairments
Time
Time Varying Statistically Based IP
Network Impairment Condition (IC)
IC1
LOO X%
IC2
LOO X%
IC100
LOO X%
• Each Impairment Condition is assigned a Likely-hood of
Occurrence (LOO) based on real IP Network Statistics, Network
Architecture, Classes of Service
• The goal is to have approximately 100 test combinations so that
an automated run of the test suite completes in less than a day.
Test Profiles Based on QoS Classes
Test Profiles
QoS Class
(Y.1541)
Applications (Examples)
Node Mechanisms
A
(VoIP, MoIP,
FoIP, ToIP)
0
Real-Time, loss sensitive, Jitter
sensitive, high interaction (VoIP, VTC)
B
(VoIP, MoIP,
FoIP, ToIP)
1
Real-Time, Jitter sensitive, interactive
(VoIP, VTC).
C
(FoIP only)
2
Transaction Data, Highly Interactive
(Signaling)
3
Transaction Data, Interactive
4
Low Loss Only (Short Transactions,
Bulk Data, Video Streaming)
Long Queue, Drop priority
Any route/path
5
Traditional Applications of Default IP
Networks
Separate Queue (lowest priority)
Any route/path
Strict QoS. Guaranteed no over
subscription on links.
Separate Queue with preferential
servicing, Traffic grooming
Network Techniques
Constrained Routing and Distance
Less constrained Routing and
Distances
Constrained Routing and Distance
Separate Queue, Drop priority
Less constrained Routing and
Distances
• Statistically based models can be created for different
QoS Classes
Example of Network Model Coverage
(NMC) Curve
QoS, PESQ, PSQM, MOS, Throughput, Connect Rate, etc.
Parameter X Vs Network Model Coverage Percentage
Device A
Device B
Device C
0
0
10
20
30
40
50
60
70
Percentage of Network Coverage
80
90
100
Value of Converged Network Model
• Predicts product performance under statistically base network
conditions
•
•
•
•
Finds design weaknesses
Find compatibility issues between network equipment
Facilitates isolating and resolving field problems
Assists in evaluating different technologies
Target Audience for Converged Network
Model
•
•
•
•
•
•
Operating Companies
Service Providers
Manufacturers
Design Engineers
Test houses
Magazines and product reviewers
Discussion
•
•
•
Comments, Suggestions and Recommendations
Input for Network Model
– IP Network Statistics
– Network Architecture
– Test Scenarios
Invited to participate in TR30.3