halar e-ctfe - Métallisation Nord Industrie

Download Report

Transcript halar e-ctfe - Métallisation Nord Industrie

HALAR E-CTFE
Thermoplastique coating
HALAR E-CTFE is a high performance meltprocessable fluoropolymer
Key properties
• Complex coating and performed pieces
• To obtain layers without any porosity from 300 µm – to 1500 µm
• Excellent thermal stability
• Exceptional resistance to the chemicals
• Excellent electrical properties
• Radiation resistance
• Good mecanical properties
• Thermal resistance
• Flame proofness
• Coating on all size of pieces
HALAR is chemically resistant to most
industrial acids, bases and solvents.
No known solvent dissolves or stresscracks
HALAR up to 120°C.
HALAR has a very low and stable
dielectric constant (2.5) on different
temperatures and frequencies.
His dielectric strength : 80 Kv/mm.
Mechanical properties
High resistance polymer with good mechanical
properties : abrasion and shocks resistance,
hardness, resistance to deformation.
The coated pieces can be worked by turning,
drilling, boring, grinding on required dimentions.
CHEMICAL INDUSTRY
ELECTRICAL INDUSTRY
MECANICAL ENGINEERING INDUSTRY
AUTOMOBILE INDUSTRY
AERONAUTIC INDUSTRY
Métallisation Nord Industrie – rue d’Arcole 51 bis – 59000 Lille – Tel: +33 3 28 38 05 50 – Fax: +33 3 20 30 98 72
E-mail: [email protected] – website: www.mni-hi-tech.com
HALAR E-CTFE
Thermoplastique coating
HALAR E-CTFE is a high performance meltprocessable fluoropolymer
BRANCHES OF INDUSTRY
CHEMICHAL INDUSTRY
All type of recipients, membranes, tank coatings,
pumps and pump elements, valves, piping systems,
reactors, fan heathers, centrifuges, heat exchangers.
Others planned uses : tubes and pipes, valves seats,
Filters, dusts catchers, separators, packing of corrosive
chemicals.
ELECTRICAL INDUSTRY
Pump element and drive units for underwater or
Underground utilisations.
Elements in contact with corroding matters as
control and transmission boards, cables connections
or cables clips, bobbin reinforcement, binders, jacks,
insulating pieces, cover resistor, sheet, tubes, pieces
with mecanical seals, battery boxes, fuel cell
membranes, flexprints, fireproof cables.
MECANICAL ENGINEERING INDUSTRY
Pumps elements, valves, jointing elements,
fittings elements, screw conveyors,
transporting plants.
AUTOMOBILE AND AERONAUTIC INDUSTRY
HALAR is used for wear stress accessories.
With a high chemical and shocks resistance,
and incredible elasticity properties.
Métallisation Nord Industrie – rue d’Arcole 51 bis – 59000 Lille – Tel: +33 3 28 38 05 50 – Fax: +33 3 20 30 98 72
E-mail: [email protected] – website: www.mni-hi-tech.com