Transcript Nasty Reality

Nasty Realities
EECS 150 – Lab6
Spring 2001
By Steve Fang
Topics
• Capacitive loading vs. Propagation delay
• Reflection vs. Termination
• Capacitive coupling
Ideal vs. Reality
Ideal
Reality
Components (1)
• Breadboard
• Connected underneath with metal contacts
• Know how to make parallel resistors
Figure 1a Breadboard connections
Components (2)
• Ribbon Cable with 16-pin Dip connector
Figure 1b Ribbon cable DIP plug
Components (3)
• Resistors and Capacitors
• Lab handout has some examples of how to
identify a resistor and a capacitor
• Example: red-black-brown = 200 ohm
(red=2, black=0, brown=1)
Components (4)
• 74F04PC hex inverter chip
• It has 6 inverters in it
• Don’t forget to ground pin 7 and connect
pin 14 to Vdd
Figure 2b 74F04PC hex inverter pinouts
Propagation delay (1)
• What is it???
• It is defined to be the time between the 50%
transition points of the input and output
Propagation delay (2)
• TpLH and TpHL together define the total
propagation delay
Tp = (TpLH + TpHL) / 2
• What causes the delay???
Capacitive Loading
• Treat capacitor as a water bucket
• The bigger the capacitor, the bigger the bucket
• Treat inverter as a faucet
• Filling the bucket takes time
Capacitive Loading vs.
Propagation Delay
• Bigger fanout means lumping more capacitors
at the output and thus longer time to fully
charge up the capacitor
Ring Oscillator
• An odd number of inverters in a circular chain
• No stable operation point exists; thus oscillates
• Oscillates with a period T = 2 * Tp * N
• In the lab, you will see that the frequency is
dependent on the capacitive load at the output
of the inverter
Figure 2a 5-stage ring oscillator
Transmission Line (1)
Figure 3 More realistic model of a wire
• A more realistic and accurate model of a wire is
with inductance, resistance, and capacitance
• As the wire gets longer, the effect can dominate
the speed of the signal
Transmission Line (2)
• First major problem is that signals with
high frequencies might get smeared out
• Second major problem is that signals might
reflect back and forth on the wire, taking a
long time to settle down to a definite value
Termination
• Wire has a characteristic impedance
• Your job is to match that impedance at the
end of the wire
• Example: If the ribbon cable has a characteristic
impedance of 100 ohms, then you should have
100 ohms at the output end of the cable
Capacitive Coupling
Figure 4 Capacitive Coupling
• In between two wires, there is always capacitive
coupling which introduces an interference called
cross-talk
• We need to eliminate the cross-talk
Shielding
• Shield the wires with either
Gnd or Vdd
Note
• In this lab, you will not need to use Xilinx 
• The lab is really easy and so you should spend more
time studying for the midterm 