Transcript VIvanov_20071023

A Stabilization Technique for
Phase-Locked Frequency Synthesizers
Tai-Cheng Lee and Behzad Razavi
IEEE Journal of Solid-State Circuits, Vol. 38, June 2003
Vladimir Ivanov
October 23, 2007
Outline









Integer-N PLL frequency synthesizer
Conventional architecture
Two proposals
Delay network
Synthesizer design
Simulations
Experimental results
Performance
Summary
2
Integer-N PLL frequency synthesizer




Phase-frequency Detector (PFD) compares phases
and sends voltage pulses to CP
Charge Pump (CP) converts the voltage pulses
into current pulses
Loop filter converts current pulses into a voltage
level
Voltage-controlled Oscillator (VCO) produces
frequency proportional to its control input
3
Conventional architecture





R1 provides the stabilizing zero
C2 lowers the ripple on Vcont
C1 determines the settling time
Tight tradeoff: settling time vs. ripple on Vcont
Goal: relax this tradeoff
4
Overview

To avoid overdamped settling, C2 ~ C1/10


Idea: stabilize by creating a zero without the
resistor


Thus, C1 both defines the switching speed and
suppresses the ripples
Approach: create a zero through a discrete-time
delay




Therefore, C1 has to be large
Achieves both fast settling and small ripple
Obviates the resistor in the loop filter => digital CMOS
“Amplifies” the value of the loop filter capacitor
=> saves die area
Two proposals: delay before and delay after CP2
5
Proposal 1: delay before CP2





CP1 drives C1 directly
CP2 injects charge in C1 after time ΔT
Transfer function:
Zero:
To have ωz low enough and desired loop
behavior, ΔT ~ 500 ns
6
Proposal 1: delay before CP2

Problems with Proposal 1
1.
The delay line has to:


2.

provide very large ΔT and
accommodate a wide range of
UP and DN pulsewidths
ΔT varies with process and temperature;
therefore, the damping factor (and thus the
stability) may be affected because
Proposal 2: place the delay line after CP2
7
Proposal 2: delay after CP2

If loop settling time >> 1/fREF and C2>>C1:



C2 value “amplified” by 1/(1-)
ωz achieved without resistors
damping factor much less depended on process
and temperature
8
Delay network
9
Synthesizer design
10
Comparison with conventional architecture


Loop filters: type A (delay-sampled) and
type B (conventional)
Gain: about 10 dB lower sidebands
11
Simulations

Simulation takes very long time due to:



Very different time scales
Large number of devices
Two models to speed up the design:


Linear discrete-time model (in Matlab):
to compute optimal CP current, C1 and Cs
Transistor-level model: to study the
nonidealities of PFD, CP, and VCO
1.
2.
Time contraction: fREF scaled up by 100;
C2 and M scaled down by 100
Divider realized as a simple behavioral
model with ideal devices
12
Experimental results
13
Experimental results
14
Performance
15
Summary

Proposed PLL stabilization technique
by creating a zero in the open-loop TF
which:



Relaxes the tradeoff between the settling
time and ripple on the VCO control
voltage
Makes the resistor in the loop filter
unnecessary
“Amplifies” the loop filter capacitor,
saving die area
16
VCO design

Inductors:



Varactors:


180μm x 180μm
~ 14 nH with Q = 4 (100 fF)
160 fF with tuning range ~ 12%
VCO phase noise: -120 dBc/Hz at 1 MHz
17