Transcript Common OSHA violations in CTE labs

COMMON OSHA
VIOLATIONS IN
CTE LABS
Based on data collected over years of
safety walkthroughs
MSDS BINDER IS NOT UP TO DATE

Employees right to know of hazardous chemicals (violation)

Update information and discard obsolete product sheets
UNLABELED CONTENTS
E.G.,
SPRAY BOTTLES THAT HAVE BEEN
DILUTED FROM
CONCENTRATE

Possible health and environmental hazard

Hazardous Communications (violation)

Identify content of health hazard – (eye irritant, skin irritant,
etc.)

Identify environmental hazard – ( flammable, corrosive, etc.)

If you cannot properly identify dispose content
EXTENSION CHORD UTILITY BOX



Shock hazards due to physical damage (violation)
Improper use of electrical box which should be wall
mounted and connected to a conduit (violation)
Discard and purchase correct amperage rated extension
chord for powered tools
ELECTRICAL MULTI-STRIP
TIED TO FRAME



Indicates a permanent use if anchored or tied down (violation)
Make sure it is used for electronic devices. Many labs
improperly use it for power tools
Remove tie/screw and use velcro
MISSING KNOCKOUTS TABS

Shock hazard (violation)

Purchase plug inserts

De-energize and tag out
GROUND PIN MISSING
OR RECEPTACLE NOT GROUNDED

Shock hazard (properly grounded plug is shown)
(violation)

Cut chord and notify administration of hazard

De-energize circuit breaker (receptacle) tag out
OXYGEN TANKS MISSING PROTECTIVE
COVER AND NOT SECURED VERTICALLY

Propulsion hazard, fire hazard, fall hazard (violation)

Isolate, secure and tag out.

Purchase protective covering and Tag out

Chain tanks that have covers securely
MACHINE GUARD GRINDER OUT OF
ACCEPTABLE TOLERANCES


Possible fingers abrasion, flying of stock and explosion of
grinding stone wheel (violation)
Adjust to 1/8 at rest and ¼ at top
PULLEY/BELT EXPOSED ON POWER TOOLS


Hazard to get operator or bystander’s hand, clothing caught
in the belt or pulleys (violation)
Tag out and purchase proper belt guards for power tool
ANCHORING OF EQUIPMENT


Tip hazard (violation)
Use proper anchoring bolts to secure equipment
NON COMPLIANT OSHA NOZZLE

Embolism and eye hazard when used in cleaning (violation)

Discard and purchase OSHA compliant nozzle (bottom)
UNIDENTIFIED CIRCUIT
BREAKERS


Shock and start up hazard when conducting
maintenance (violation)
Update and correctly name circuit breakers
TOOLS TO HELP YOU IDENTIFY HAZARDS

Circuit finder

Ground fault tester

Voltage detector
o Measuring tape
o Extra batteries
o Camera
SAFETY STARTS WITH YOU!
APPLY YOUR KNOWLEDGE!
 You
are the keeper of your grounds
 An injury in any school is a lost for all
Make it safe…
It is the right thing to do!