Transcript ECE 364 - Power Electronics

Battery Management for Maximum
Performance in Plug-In Electric
and Hybrid Vehicles
P. T. Krein
Dept. of Electrical and Computer Engineering
University of Illinois at Urbana-Champaign
Acknowledgements
• Thanks to Ryan Kroeze for literature work
and analysis contributions.
• A version of this presentation was delivered
at the IEEE Vehicle Propulsion Power
symposium in September.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
2
Outline
•
•
•
•
•
•
•
Performance requirements
Present situation
Lead-acid cells
NiMH cells
Li-ion cells
Battery management components
Conclusion
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
3
Performance Requirements
• Hybrid vehicles
–
–
–
–
–
–
High power density, meaning:
High charge acceptance for braking
High power delivery for acceleration
Cycle life – tens of thousands of shallow cycles
Adequate energy density, but this is secondary
Wide ambient temperature range
• Electric vehicles
1 cycle/5 mi
over 100,000 miles
– High energy density
– Fast, reliable charging
– Cycle life – thousands of deep cycles
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
4
Plug-In Hybrids
• Require the power capabilities and cycling
capabilities of hybrids.
• Benefit from high energy density and good
recharge properties.
• In other words: must satisfy everyone and
everything.
• This motivates work on “hybrid storage” that
combines batteries (high energy density) with
ultracapacitors (high power density).
• Here we explore the batteries.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
5
Present Situation
• EVs and HEVs require thousands of battery
cycles with minimal degradation.
• Typical strategy derates batteries:
use a narrow state of charge (SOC)
regime.
• This results in a low “effective energy
density” in exchange for power density.
• Space applications get much more.
UoSat-5
University of Surrey
• The presentation emphasizes ways to
maximize battery capabilities
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
6
Present Situation
• NiMH cells today are being used
in about a 15% SOC range.
Reasons are explored here.
• Lead-acid cells provide a similar
range.
• Li-ion cells are more promising.
• Active balancing that works
throughout the SOC range is
an important enabler.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
7
Lead-Acid Cells
• Operating results from starting-lightingignition (SLA) batteries.
• Consistent with float operation in telecom.
• Best life results above 85% SOC.
• But the top end involves gassing reactions
and sacrifices efficiency.
• Energy density is about 35 W-h/kg given
100% discharge cycles.
• Effective energy density (15%) is
5.3 W-h/kg.
• Ultracapacitors can do as well.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
8
Lead-Acid Cells
• Cells show damage from sulfation when
operated at lower SOC.
• Present designs should be able to support an
SOC range of 50% to 100%, but only if the
batteries are stored full.
• Promising future designs are likely to correct
the most severe damage
mechanisms.
• Do not favor HEV and EV
applications except on a
“use, park, charge” cycle.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
9
NiMH Cells
• Extensive data in preparation for and from
experience with commercial hybrids.
• Toyota has had few
problems with Prius
traction batteries –
routine replacement
has not been required.
• Limited SOC swing – about 50% to 65%.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
10
NiMH Cells
• Given density of 70 W-h/kg for full discharge,
the effective density is less than 10 W-h/kg.
• The argument can be made that these
designs use nickel-metal-hydride batteries for
the functions of ultracapacitors.
• What aspects is this application attempting to
optimize?
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
11
NiMH Cells
• At the high end, positive electrode
degradation and electrolyte loss occurs.
• Positive pressure can transfer hydrogen
among adjacent cells but amplifies
degradation and imbalances cells.
• At the low end, the negative electrode
experiences irreversible oxidation.
• Impedance rises for discharge.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
12
NiMH Cells
• High-end effects are minimized if SOC is
limited well below 80%.
• Low-end effects are strong below 20% SOC,
but performance degrades to some degree
below 40% SOC.
• External active balancing helps maintain
discharge performance between 20% and
40% SOC, and limits degradation above 80%.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
13
NiMH Cells
• Differential power density is the remaining
issue. (Here DOD = 100% - SOC.)
From Menjak, Gow, Corrigan, Venkatesan, Dhar, Stempel, Ovshinsky,
“Advanced Ovonic high-power nickel-metal hydride batteries for hybrid
electric vehicle applications,” in Ann. Battery Conf. Appl. Advances, 1998, pp. 13-18.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
14
NiMH Cells
• The reduction in charge power density as the
high end has been treated as a limiting factor:
regeneration energy acceptance drops
rapidly above 60% SOC.
• The SOC range from 20% to 80% can be
utilized if
– Active balancing over the whole range prevents
local limitations from pulling cells out of balance
between 20% and 40% SOC, and between 60%
and 80% SOC.
– Braking strategy limits charge power at the high
end.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
15
NiMH Cells
• Thus the SOC range from 20% to 80% can
be used for plug-in operation.
• Increases effective energy density to 42 Wh/kg – factor of 4 improvement.
“Harding Handbook for Quest Batteries,” Fig. 3.7.2,
available http://www.hardingenergy.com/pdfs/NiMH.pdf
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
16
Li-Ion Cells
• Lithium-ion cells in general have much better
reversibility than other common secondary
chemistries: Energy reversibility can exceed 90%.
of Charge
• Discharge curves indicateState
regimes
of reduced
reversibility. 4.2
Pack Type 1
Pack Type 2
OPEN Cell Voltage
4.1
Pack Type 3
4
3.9
3.8
3.7
3.6
3.5
100
80
60
40
20
0
Capacity (pct)
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
17
Li-Ion Cells
• Experience with laptop computers is showing
that Li-ion cells degrade under float
conditions: extended operation when held at
100% SOC decreases operating life.
• Life testing in telecom applications shows that
limiting the upper end charge voltage reduces
degradation substantially.
• The effect is similar to limiting SOC to less
than 90%.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
18
Li-Ion Cells
• The curve shown earlier shows rapid
imbalance and capacity reduction below 20%
SOC.
• Key problem: cell
balancing – no inherent
mechanism in Li-ion.
• Typical systems use
resistive limiters to
enforce the upper voltage limit. www.popularmechanics.com
• Limiters add system nonlinearity that drives
(lossy) cell balancing at the top end of SOC,
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
19
Li-Ion Cells
• Balancing is more important at the low end,
where discharge effects begin to pull cells
apart.
• In reality, a method is needed that can balance
over the entire useful SOC range.
• When this is done, the possible range of SOC
becomes 20% to 90%.
• If the cells achieve 200 W-h/kg for 100%
discharge, the effective energy density is 140
W-h/kg – more than triple the best NiMH
results.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
20
Battery Management Components
• Vehicle system-level control strategy must
focus on a limited SOC range, as present
hybrids do.
• The proven long-life SOC range is
considerably wider than in present practice.
• Components:
– Strategies with active top-end and bottom-end
SOC limits.
– Active cell balancing over the full range.
– Techniques to limit or mitigate power density
requirements at extremes.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
21
Choices for Limits
• Use established charge sustaining strategies,
but open the tolerance bands.
– NiMH: 50%  30% SOC range
– Li-ion: 55%  35%
• Target a daily driving and charging profile.
– Seek to end the day at the low end, ready for
charging.
– Allow a high SOC pack to decrease slowly during
the daily drives.
• Adaptive cycle intelligence.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
22
Choices for Mitigation
• Divert power demand extremes to
ultracapacitors – but only at the extreme SOC
ends.
• This leads to relatively small ultracapacitor
packs that absorb as little as 10% of a given
braking energy sequence or deliver just 20%
of peak acceleration power
• Use resistive brake auxiliaries
when SOC upper limit is reached.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
23
Active Cell Balancing
• In Li-ion packs, cell mismatch is not restored
by altering the charge process alone.
• The cells can be pulled apart at the low end of
SOC, especially for high power pulses.
• Resistive or switched voltage limiters can only
function at the high end.
• In HEV applications, there is limited dwell time
at the high end.
• In EV applications, limiters must follow the
SOC limit settings.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
24
Active Cell Balancing
• Active balancing methods bring cells
together regardless of SOC.
– Switched capacitor types – low energy use,
efficiency is high as mismatch reduces.
– Switched inductor types – drives current to
match charge in a controller manner.
– Individual cell or monoblock chargers – the
ultimate, but expensive, solution.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
25
Discussion
• Present lead-acid cells are comparatively
weak for plug-in hybrid applications.
• NiMH cells can be used for swings between
20% and 80% SOC, achieving effective
energy densities of 40-50 W-h/kg in plug-in
applications. Based on known results from
commercial hybrids, this should be viable.
• Li-ion cells can be used for swings between
20% and 90% SOC, achieving effective
energy densities of 140 W-h/kg or more.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
26
Discussion
• All can have efficiency enhanced with
ultracapacitors as auxiliaries.
• The application in the stated range is
predicated on active battery management,
especially active balancing.
• There are commercial Li-ion batteries that
have been matching the claimed performance
specs and should be able to perform to the
requirements.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
27
Discussion
• Is it enough?
• In city driving, a well-designed car needs no
more than 80 W-h/km (125 W-h/mile).
• At 140 W-h/kg, 100 kg of Li-ion batteries
could deliver 175 km of all-electric city range.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
28
Conclusion
• There is growing knowledge of considerations
for maximum battery performance in the
context of plug-in hybrids.
• Li-ion cells should be able to deliver more
than ten-fold effective energy density
improvement compared to present hybrid
strategies.
• For all cell types, limiting the SOC range is
vital for longevity.
• Cell balancing to permit arbitrary SOC levels
also appears to be vital.
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
29
Questions and Discussion
Grainger Center for Electric Machines and Electromechanics
University of Illinois at Urbana-Champaign
30