Transcript Configuring Linksys Wireless Ethernet Bridge

Configuring Linksys Wireless
Ethernet Bridge
Prof. Yousif
@
Valencia Community College
Wireless Ethernet Bridge
• Home Page
• Default Address
192.168.1.225
Enable LAC#5
The default SSID is “linksys” unless a
beacon is heard with a different SSID
Basic Configuration
Default PW
is: admin
admin
Change to WB#, where
“#” refers to your PC
number
Basic Configuration
Auto sensed from the beacons
broadcasted by the Cisco AP
Basic Configuration
Must
enter GW
Address
No Security Config. “Later”
Confirm!
Web Access: Open your browser and type the
address you used during configuration: 10.0.0.3
Make sure that you Ethernet Card is configured
to be on the same network
Confirm Association
IP Add. Of PC
MAC Add. Of W. Bridge
Check the Firmware Version
Old
Upgrade the WB Firmware
Download the firmware
Capture
Install firmware Upgrade
Make Sure that you enter the correct IP
address of the WB and the correct password
Site Survey
Supports WEP Only,
Doesn’t Support WPA