Transcript Huang Slides 1 V08

Antennas: from Theory to Practice
1. Basics of Electromagnetics
Yi HUANG
Department of Electrical Engineering & Electronics
The University of Liverpool
Liverpool L69 3GJ
Email: [email protected]
Antennas: from Theory to Practice
1
Objectives of this Chapter
• Review the history of RF engineering and
antennas;
• Lay down the foundation of mathematics
required for this course;
• Examine the basics of electromagnetics and
• introduce Maxwell’s equations to establish
the link between the fields and sources.
Antennas: from Theory to Practice
2
1. 1
The First Successful Antenna Experiment
It was conducted by Hertz
in 1887
Experimental set-up
Antennas: from Theory to Practice
3
1.2
Radio Systems
• Compared with a wired system, radio systems can
offer the following advantages:
– Mobility
– Good coverage over an area
– Low path-loss over a long distance
A typical radio system
Antennas: from Theory to Practice
4
1.3
Necessary Mathematics
• Complex numbers
Antennas: from Theory to Practice
5
• Vectors
– A vector has both a magnitude and a direction
Antennas: from Theory to Practice
6
• Vector addition and subtraction
Antennas: from Theory to Practice
7
• Vectors multiplication:
– dot product:
– cross product:
Cross product doesn’t obey
the commutative law!
Antennas: from Theory to Practice
8
An Example
Antennas: from Theory to Practice
9
• Cartesian and spherical coordinates
Antennas: from Theory to Practice
10
1.4
Basics of Electromagnetics
l (m)
f (Hz)
Antennas: from Theory to Practice
11
Radio Frequency Bands
Frequency Band Wavelength Applications
•
•
•
•
•
•
•
•
•
3-30 kHz
30-300kHz
0.3-3 MHz
3-30 MHz
30-300MHz
0.3-3 GHz
3-30 GHz
30-300GHz
0.3-3 THz
VLF
LF
MF
HF
VHF
UHF
SHF
EHF
100-10 km
10-1 km
1-0.1 km
100-10 m
10-1
m
1-0.1 m
100-10mm
10-1 mm
1-0.1 mm
Navigation, sonar, fax
Navigation
AM broadcasting
Tel, Fax, CB, ship comms
TV, FM broadcasting
TV, mobile, radar, satellite
Radar, microwave links
Radar, wireless comms
Sub-millimetre application
Antennas: from Theory to Practice
12
dB
• Logarithmic scales are widely used in RF
engineering and antennas community since the
signals we are dealing with change significantly
but
Antennas: from Theory to Practice
13
The Electric Field
• The electric field (in V/m) is defined as the force
(in Newtons) per unit charge (in Coulombs). From
this definition and Coulomb's law, the electric field
E created by a single point charge Q at a distance r
is
e is the electric permittivity, also called dielectric constant
In free space:
Antennas: from Theory to Practice
14
• The product of permittivity and the electric field is
called the electric flex density (also called the
electric displacement), D which is a measure of
how much electric flux passes through a unit area,
i.e.,
The complex permittivity can be written as
The ratio of the imaginary part to the real part is called
the loss tangent
Antennas: from Theory to Practice
15
Relative permittivity of some materials
Antennas: from Theory to Practice
16
• The electric field E is related to the current density J
(in A/m2), another important parameter, by Ohm’s
law:
J  E
 is the conductivity which is the reciprocal
of resistivity. It is a measure of a material’s ability to
conduct an electrical current and is expressed in
Siemens per metre (S/m).
Antennas: from Theory to Practice
17
Conductivity of some materials
Antennas: from Theory to Practice
18
The Magnetic Field
• The magnetic field, H (in A/m), is the vector field
which forms closed loops around electric currents
or magnets. The magnetic field from a current
vector I is given by the Biot-Savart law as
H
I  rˆ
4r 2
Antennas: from Theory to Practice
19
• Like the electric field, the magnetic field exerts a
force on electric charge. But unlike an electric field,
it employs force only on a moving charge, and the
direction of the force is orthogonal to both the
magnetic field and charge's velocity
Antennas: from Theory to Practice
20
Relative permeability of some materials
Antennas: from Theory to Practice
21
Qv can actually be viewed as the current vector I and
the product of is called the magnetic flux density
B (in Tesla), the counterpart of the electric flux
density.
When we combine the electric and magnetic fields,
the total force:
This is called the Lorentz force. The particle will
experience a force due to the electric field of QE,
and the magnetic field Qv × B
Antennas: from Theory to Practice
22
1.5
Maxwell’s Equations
Maxwell’s equations describe the interrelationship
between electric fields, magnetic fields, electric
charge, and electric current
Antennas: from Theory to Practice
23
• Faraday's Law of Induction
The induced electromotive force is proportional to the rate of
change of the magnetic flux through a coil. In layman's terms,
moving a conductor through a magnetic field produces a
voltage or a time varying magnetic field can generate an
electric fields!
Antennas: from Theory to Practice
24
• Amperes’ Circuital Law
It shows that both the current (J) and time varying
electric field can generate a magnetic field.
• Gauss' Law for Electric Fields
It means that charges () can generate electric fields, and
it is not possible for electric fields to form a closed loop.
Antennas: from Theory to Practice
25
• Gauss’ Law for Magnetic Fields
It means that the magnetic field lines are closed loops,
thus the integral of B over a closed surface is zero
• Integral form
The partial
differential form
applies to a point
But this is for
an area/volume!
Antennas: from Theory to Practice
26
1.6
Boundary Conditions
Tangential components of an electric field are continuous
across the boundary between any two media.
The change in tangential component of the magnetic field
across a boundary is equal to the surface current density.
Antennas: from Theory to Practice
27
Applying these boundary conditions on a perfect conductor
Field distribution around a two-wire transmission line:
E-field is orthogonal to the line surface and H-field (loops).
Antennas: from Theory to Practice
28