Transcript SI units

ECE 101
Exploring Electrical Engineering
Chapter 2
Terms and Formulae
Herbert G. Mayer, PSU
Status 2/2/2016
1
Syllabus





SI
What is . . . ?
Passive Sign Convention
Electric Sources
References
2
SI
 SI is the abbreviation from French name: Le Système
International d'Unités
 Standards published in 1960 as the result of an
initiative started in 1948; they are based on the
meter-kilogram-second (MKS) system
 SI is formally declared to be evolving, so some will
change, but if so, then per international agreement
 change: kilogram, Ampere, Kelvin, mole
 Replace by specifying via: Planck-, Boltzman-, and
Avogadro-constants
3
SI
 Replace by specifying via constants that can be
reproduced in a good lab
 No need to measure temperature, gravity, air
pressure, etc. at some location, which might make
measurement location-dependent; i.e.:
 Reason for change is technological evolution,
allowing more and more precise definitions
 The corresponding American organization is NIST:
 National Institute for Standard and Technology
4
SI 7 Base Units
5
SI Units
 m: meter – is length of light traveled in
1/299,792,458th of a second
 kg: kilogram – equal reference prototype; will likely
change
 s: second – duration of 9,192,631,770 periods of
radiation corresponding to the transition between
the two hyperfine levels of the ground state of
cesium 133 atom
 A: ampere – current which in 2 parallel conductors 1
meter apart in vacuum produces a force of 2 * 10-7
newton per meter of conductor
6
SI Units
 K: Kelvin – thermodynamic temperature unit that is
the 1/273.16 fraction of water temperature at triple
point
 mol: mole – is amount of substance of a system
which contains as many elementary entities as there
are atoms in 0.012 kilogram of carbon 12; entities
can be atoms, molecules, electrons
 Old definition: the mole is the amount of substance
that contains 6.022,141,79 x 1023 specified
elementary entities
 cd: candela – is luminous intensity of a source that
emits monochromatic radiation of frequency 540 *
1012 hertz, plus some further constraints
7
Changes Coming
Per 2011 declaration, the kilogram, the ampere,
the degree kelvin, and the mole, will be
redefined in terms of invariants of nature
New definitions will be based on fixed
numerical values of the Planck constant (h), the
elementary charge (e), the Boltzmann constant
(k), and Avogadro constant (NA), respectively
See [4]
8
What is . . . ?
 An electron? Subatomic particle with electric
charge; we call that charge negative; part of lepton
family
 Called an elementary particle, since it seems to have
no sub-particles
 Has mass of approx. 1/1836 of a proton
 Yet electrons have properties of particles AND
waves
9
What Is?
 A coulomb? Is a fundamental unit of electrical
charge, and is also the SI derived unit of electric
charge; the symbol for Coulomb is C; the symbol
for charge flowing, creating a current, is: Q or q
 A coulomb is equal to a charge of approximately
6.241×1018 electrons
 Now what a charge really is, we don’t understand,
but we do know some key properties, and we can
measure it quite accurately
 Similar to gravity: we can measure and use it, but
we don’t fundamentally understand what it is; we
only observe how it works
10
What is?
 An ampere? Unit of current. One of the base units of
the SI
 Named after André Marie Ampère, French physicist
1775 – 1836
 When about 6.241 * 1018 electrons stream though a
conductor in a second, the amount of charge moved
is 1 C and the current 1 A; AKA “amp”.
i = dq / dt
1A=1C/s
C here: Coulomb! Not capacitance
11
What is?
 A Volt is the SI unit of electrical force to push one
ampere of current against a one Ω resistance
 Or the electric potential difference between 2 points
of a conductor when a current dissipates one watt
 A Volt is AKA the potential difference between 2
planes that are 1 m apart with an electric field of 1
newton / coulomb
 It is NOT one of the 7 base units on page 4!
 In the mks system, the dimension is:
V = kg * m2 / ( A * s3 )
12
What is?
 A Volt is named named in honor of the Italian
physicist Alessandro Volta (1745-1827), inventor of
the first voltaic pile (chemical battery)
 A Volt is Amperes times Ohm, Watts per Ampere, or
Joules per Coulomb:
V=A*Ω
V=W/A
V=J/C
V = dw / dq
13
What is?
 Electrical power, like its mechanical equivalent, is
the ability to do work
 Is measured in Watt, unit dimension shown as W, in
equations sometimes denoted by letter p
 Is the ability to do the work of a 1 Coulomb charge
every second, when passing through a field of 1 V
p=v*q/t=v*i
p = dW / dt = ( dW / dq ) * ( dq / dt ) = v * i
14
What is?
 Electrical resistance? A material’s opposition to the
free flow of electrons
 In an insulator, such as vacuum or porcelain,
resistivity is very large, typically >> 1 MΩ (Mega
Ohm)
R ~ ki * length / Area
A
I
15
What is?
 Resistance Continued: In a conductor, such as
silver, carbon (graphene) or copper or gold,
resistivity is very small
 Resistance is expressed in units of Ohm, symbol: Ω
 Resistance grows proportional to the length l of
conducting material, and decreases inversely
proportional to the diameter A of the conductor; ki
being a material constant!
R~l/A
R = ki * l / A

ki
l
A
being a constant depending on material
being the length
being the diameter of the conducting material --not ampere!
16
What is?
 Electrical inductance? A charge in motion (e.g. some
current) creates a magnetic field around its conductor
 If the current remains constant, so does the field
 If current i varies over time, the magnetic field also
changes as a direct function. A time-varying magnetic
field induces a voltage in any conductor linked to the
field; linked meaning it is close-by
v ~ di / dt
v = L * di / dt
v
L
di
measured in Volt V
inductance in Henry H
the change in current A
17
What is?
 Electrical inductance and related power and energy?
p=i*v
p = i * L * di / dt
w=(L/2)*i2
w
p
L
i
di
the energy in Joule
the power measured in Watt
the inductance in Henry H
the current in A
the change of current over time, in A
18
What is?
 Electrical capacitance? Circuit parameter capacitance
is represented by the letter C, measured in farad F. A
capacitor does not directly conduct current, since an
insulator separates its 2 plates
 But a charge placed onto one plate repels similarly
charged particles on the other plate, and so can
cause a charge to move; known as displacement
current. The current so created is proportional to the
rate at which the voltage across the plates varies
over time. Note: farad is a very large unit; thus in
diagrams we see smaller units, such as μF or nF.
i ~ dv / dt
i = C * dv / dt
i
the resulting current in A, caused by the changing voltage
C the capacitor’s capacitance, measured in farad
dv the change in voltage across the 2 plates
19
What is?
 A capacitor’s power p and energy w?
p=v*i
p = C * v * dv / dt
w = C * v2 / 2
w
p
i
C
dv
energy in Joule
power v measured in Watt
the displacement current, in A
is the capacitor’s capacitance, measured in farad
the change in voltage across the 2 plates
20
Passive Sign Convention
 Assigning a reference direction for current or
voltage in a circuit is arbitrary
 Used consistently, any method works out fine
 The most widely used method is the Passive Sign
Convention:
 When the reference direction for the current in a
passive element is in the direction of the voltage
drop across that element, use a + sign in any
expression that relates current to voltage
 Else use the - sign. That convention we call the
Passive Sign Convention
21
Electric Sources
We use 4 types of electric sources:
1. Constant voltage sources
2. Constant current sources
3. Dependent voltage sources, and


Can depend on separate voltage
Other kinds depend on separate current
4. Dependent current sources


Can depend on separate voltage
Other kinds depend on separate current
22
References
1. Electric Circuits, 10nd edition, Nilsson and Riedel,
Pearsons Publishers
2. SI Units from NIST:
http://physics.nist.gov/cuu/Units/units.html
3. NIST Special Publication 330, © 2008 Edition, by
Taylor and Thompson, lists the SI units
4. Peter Mohr, NIST Publication “Redefining the SI Base
Units”, November 2., 2011
23