Transcript Chapter 11 ATM - National Chi Nan University

William Stallings
Data and Computer
Communications
7th Edition
Chapter 11
Asynchronous Transfer Mode
Protocol Architecture
• Similarities between ATM and packet switching
—Transfer of data in discrete chunks
—Multiple logical connections over single physical
interface
• In ATM flow on each logical connection is in
fixed sized packets called cells
• Minimal error and flow control
—Reduced overhead
• Data rates (physical layer) 25.6Mbps to
622.08Mbps
Protocol Architecture (diag)
Reference Model Planes
• User plane
—Provides for user information transfer
• Control plane
—Call and connection control
• Management plane
—Plane management
• whole system functions
—Layer management
• Resources and parameters in protocol entities
ATM Logical Connections
•
•
•
•
•
•
•
Virtual channel connections (VCC)
Analogous to virtual circuit in X.25
Basic unit of switching
Between two end users
Full duplex
Fixed size cells
Data, user-network exchange (control) and networknetwork exchange (network management and routing)
• Virtual path connection (VPC)
— Bundle of VCC with same end points
ATM Connection Relationships
Virtual Channel Terminology
Virtual Path Terminology
VPI
VP/VC Switching
VPI 1
VPI 3
VCI 1
VCI 2
VCI 3
VCI 1
VCI 2
VCI 3
VPI 2
VPI 4
VCI 1
VCI 2
VCI 3
VCI 1
VCI 2
VCI 3
VPI 3
VCI 3
VCI 4
VPI 1
VCI 1
VCI 2
VCI 3
VCI 4
VPI 4
VCI 1
VCI 2
VCI 3
VPI 2
VCI 1
VCI 2
VCI 3
VPI 5
VCI 1
VCI 2
Advantages of Virtual Paths
•
•
•
•
•
Simplified network architecture
Increased network performance and reliability
Reduced processing
Short connection setup time
Enhanced network services
Call
Establishment
Using VPs
Virtual Channel Connection
Uses
• Between end users
—End to end user data
—Control signals
—VPC provides overall capacity
• VCC organization done by users
• Between end user and network
—Control signaling
• Between network entities
—Network traffic management
—Routing
VP/VC Characteristics
• Quality of service
• Switched and semi-permanent channel
connections
• Call sequence integrity
• Traffic parameter negotiation and usage
monitoring
• VPC only
—Virtual channel identifier restriction within VPC
Control Signaling - VCC
• Done on separate connection
• Semi-permanent VCC
• Meta-signaling channel
— Used as permanent control signal channel
• User to network signaling virtual channel
— For control signaling
— Used to set up VCCs to carry user data
• User to user signaling virtual channel
— Within pre-established VPC
— Used by two end users without network intervention to establish
and release user to user VCC
Control Signaling - VPC
• Semi-permanent
• Customer controlled
• Network controlled
ATM Cells
•
•
•
•
Fixed size
5 octet header
48 octet information field
Small cells reduce queuing delay for high
priority cells
• Small cells can be switched more efficiently
• Easier to implement switching of small cells in
hardware
ATM Cell Format
Header Format
• Generic flow control
—Only at user to network interface
—Controls flow only at this point
• Virtual path identifier
• Virtual channel identifier
• Payload type
—e.g. user info or network management
• Cell loss priority
• Header error control
Generic Flow Control (GFC)
• Control traffic flow at user to network interface (UNI) to
alleviate short term overload
• Two sets of procedures
— Uncontrolled transmission
— Controlled transmission
• Every connection either subject to flow control or not
• Subject to flow control
— May be one group (A) default
— May be two groups (A and B)
• Flow control is from subscriber to network
— Controlled by network side
GFC Field Coding
Single Group of Connections (1)
• Terminal equipment (TE) initializes two variables
—TRANSMIT flag to 1
—GO_CNTR (credit counter) to 0
• If TRANSMIT=1 cells on uncontrolled connection
may be sent any time
• If TRANSMIT=0 no cells may be sent (on
controlled or uncontrolled connections)
• If HALT received, TRANSMIT set to 0 and
remains until NO_HALT
Single Group of Connections (2)
• If TRANSMIT=1 and no cell to transmit on any
uncontrolled connection:
—If GO_CNTR>0, TE may send cell on controlled
connection
• Cell marked as being on controlled connection
• GO_CNTR decremented
—If GO_CNTR=0, TE may not send on controlled
connection
• TE sets GO_CNTR to GO_VALUE upon receiving
SET signal
—Null signal has no effect
Use of HALT
• To limit effective data rate on ATM
• Should be cyclic
• To reduce data rate by half, HALT issued to be in
effect 50% of time
• Done on regular pattern over lifetime of
connection
Two Queue Model
• Two counters
—GO_CNTR_A, GO_VALUE_A,GO_CNTR_B,
GO_VALUE_B
Header Error Control
• 8 bit error control field
• Calculated on remaining 32 bits of header
• Allows some error correction
HEC Operation at Receiver
Effect of
Error in
Cell Header
Impact of Random Bit Errors on
HEC Performance
Transmission of ATM Cells
•
•
•
•
•
•
622.08Mbps
155.52Mbps
51.84Mbps
25.6Mbps
Cell Based physical layer
SDH based physical layer
Cell Based Physical Layer
• No framing imposed
• Continuous stream of 53 octet cells
• Cell delineation based on header error control
field
Cell Delineation State Diagram
Impact of Random Bit Errors on
Cell Delineation Performance
Acquisition Time v Bit Error
Rate
SDH Based Physical Layer
•
•
•
•
•
Imposes structure on ATM stream
e.g. for 155.52Mbps
Use STM-1 (STS-3) frame
Can carry ATM and STM payloads
Specific connections can be circuit switched
using SDH channel
• SDH multiplexing techniques can combine
several ATM streams
STM-1 Payload for SDH-Based
ATM Cell Transmission
ATM Service Categories
• Real time
—Constant bit rate (CBR)
—Real time variable bit rate (rt-VBR)
• Non-real time
—Non-real time variable bit rate (nrt-VBR)
—Available bit rate (ABR)
—Unspecified bit rate (UBR)
—Guaranteed frame rate (GFR)
Real Time Services
• Amount of delay
• Variation of delay (jitter)
CBR
• Fixed data rate continuously available
• Tight upper bound on delay
• Uncompressed audio and video
—Video conferencing
—Interactive audio
—A/V distribution and retrieval
rt-VBR
• Time sensitive application
—Tightly constrained delay and delay variation
• rt-VBR applications transmit at a rate that varies
with time
• e.g. compressed video
—Produces varying sized image frames
—Original (uncompressed) frame rate constant
—So compressed data rate varies
• Can statistically multiplex connections
nrt-VBR
• May be able to characterize expected traffic flow
• Improve QoS in loss and delay
• End system specifies:
—Peak cell rate
—Sustainable or average rate
—Measure of how bursty traffic is
• e.g. Airline reservations, banking transactions
UBR
• May be additional capacity over and above that
used by CBR and VBR traffic
—Not all resources dedicated
—Bursty nature of VBR
• For application that can tolerate some cell loss
or variable delays
—e.g. TCP based traffic
• Cells forwarded on FIFO basis
• Best efforts service
ABR
• Application specifies peak cell rate (PCR) and
minimum cell rate (MCR)
• Resources allocated to give at least MCR
• Spare capacity shared among all ARB sources
• e.g. LAN interconnection
Guaranteed Frame Rate (GFR)
• Designed to support IP backbone subnetworks
• Better service than UBR for frame based traffic
— Including IP and Ethernet
• Optimize handling of frame based traffic passing from
LAN through router to ATM backbone
— Used by enterprise, carrier and ISP networks
— Consolidation and extension of IP over WAN
• ABR difficult to implement between routers over ATM
network
• GFR better alternative for traffic originating on Ethernet
— Network aware of frame/packet boundaries
— When congested, all cells from frame discarded
— Guaranteed minimum capacity
— Additional frames carried if not congested
ATM Adaptation Layer
• Support for information transfer protocol not
based on ATM
• PCM (voice)
—Assemble bits into cells
—Re-assemble into constant flow
• IP
—Map IP packets onto ATM cells
—Fragment IP packets
—Use LAPF over ATM to retain all IP infrastructure
ATM Bit Rate Services
Adaptation Layer Services
•
•
•
•
Handle transmission errors
Segmentation and re-assembly
Handle lost and misinserted cells
Flow control and timing
Supported Application types
•
•
•
•
•
Circuit emulation
VBR voice and video
General data service
IP over ATM
Multiprotocol encapsulation over ATM (MPOA)
—IPX, AppleTalk, DECNET)
• LAN emulation
AAL Protocols
• Convergence sublayer (CS)
—Support for specific applications
—AAL user attaches at SAP
• Segmentation and re-assembly sublayer (SAR)
—Packages and unpacks info received from CS into
cells
• Four types
—Type
—Type
—Type
—Type
1
2
3/4
5
AAL Protocols
Segmentation and Reassembly
PDU
AAL Type 1
• CBR source
• SAR packs and unpacks bits
• Block accompanied by sequence number
AAL Type 2
• VBR
• Analog applications
AAL Type 3/4
• Connectionless or connected
• Message mode or stream mode
AAL Type 5
• Streamlined transport for connection oriented
higher layer protocols
CPCS PDUs
Example AAL 5 Transmission
Required Reading
• Stallings Chapter 11
• ATM Forum Web site