Session 04 (Intravenous Therapy)
Download
Report
Transcript Session 04 (Intravenous Therapy)
Intravenous Therapy
Advanced Care Paramedicine
Module: 7
Session: 4
Thirty years ago…
Rampart, Squad 51.
We have a 20 year old male
motorcycle rider involved in a
motor vehicle collision
complaining of neck, back and
leg pain.
He presents with compound
fractures to both femurs and has
significant blood loss.
We are requesting an order for
two large bore IV’s and Ringer’s
Lactate.
Objectives
Identify the reasons IV therapy is performed in the
prehospital setting
Identify the fluids commonly administered
State the basis of fluid and electrolyte balance
Identify factors affecting water loss
Explain the recommended uses of IV solutions
Identify common complications and reactions
Calculate a flow rate
Demonstrate proper skin cleansing and aseptic
venipuncture technique
Demonstrate proper IV cannulation technique
Why do we cannulate?
Fluid administration
Medication administration
To maintain life (electrolytes, blood…)
Do we do them to be EHSNS protocol
compliant?
IV fluids
Normal saline (0.9% NS)
Lactated Ringer’s (LR)
Also known as Hartman’s solution or RL
D5W
½ NS
D5 ½ NS
D5RL (D5LR)
Isotonic Solutions
Characteristics
Same tonicity as plasma
Osmotic pressure is the
same as the inside of the
cell
Fluid never leaves or
enters the cell
Approximate osmolarity is
240 – 340 mOsm/L
Will increase circulating
volume, which may lead to
fluid volume excess or
overload.
Solutions
2.5% dextrose/0.45%
NaCl
0.9% NaCl
Lactated Ringers
2.5% dextrose in ½
lactated ringers
6% dextan and 0.9%
NaCl
10% dextran and 0.9%
NaCl
Normal Saline
Most commonly administered IV fluid
prehospitally
IV fluid of choice for EHSNS protocols
Why?
Lactated Ringers
Composed of multiple electrolytes in
saline
Has fallen out of favor as one of main
IV fluids for treatment of traumatic
hypovolemia in past decade
Why?
Hypotonic Solutions
Characteristics
May cause blood cells to
swell and burst
May cause changes or
damage endothelial cells
Exert less osmotic
pressure than the fluid in
the extracellular
compartment
Fluid is drawn into the
cells
Approximate osmolarity <
240 mOsm/l
Solutions
0.45% NaCl
10% dextran and 5%
dextrose (slightly
hypotonic)
Hypertonic Solutions
Characteristics
May cause blood cells to
shrink
May cause dame/changes
to endothelial cells
Exert more osmotic
pressure then the
extracellular fluid
Fluid is drawn from the cell
into the vascular space
Approximate osmolarity >
340 mOsm/l
Solutions
5% dextrose/0.2% NaCl
5% dextrose/0.9% NaCl
D 5W
D10W
D50W
5% NaHCO3
10%, 15% and 20%
Mannitol
6% dextran and 0.9% NaCl
Administration Sets
The calibration of the administration
set must be known in order to
calculate the flow of the IV fluids
correctly.
Macrodrip sets
10, 15 or 20 gtts/ml
Microdrip (minidrip)
60 gtts/ml
Where do we cannulate?
Hand
Forearm
Neck
Foot
Equipment Required
Solution
Administration set
IV cannula
Tourniquet
Alcohol swab
Gloves
Sharps bin
Op site and gauze
Tape
If performing a Lock
Lock, syringe and saline
Catheter specifics
Color
Grey
Green
Pink
Blue
Size
16 G
18 G
20 G
22 G
Int Dia/Length
1.4 mm/45 mm
1.0 mm/45 mm
0.8 mm/32 mm
0.6 mm/25 mm
Max Flow
180 mls/min
80 mls/min
54 mls/min
31 mls/min
The length and diameter will affect the amount of fluid
able to be infused through the catheter
Larger diameter and shorter length gives more fluid
Small diameter and long length gives less fluid
Types of catheters
Jelco
Cathelon
Insyte
Types of catheters
Protective
Protective Plus
Administration Sets
10 gtts/ml
15 gtts/ml
60 gtts/ml
Blood sets
Vein Selection
Based on:
Condition
Palpate to confirm type of vessel
Is the pt right or left handed
Is the extremity injured
Avoid joints (stabilization)
Does the pt have a shunt (fistula)
Purpose
Straight with no turns or bumps
Location
Should be soft and spongy
Fluid replacement, Medication route, Safety line (lock)
Dictates flow rate and type of fluid to be infused
Try to use large veins for large quantities of fluid
Duration
What type of patient (trauma, cardiac or outpatient)
Patient comfort over long period of time
Prolonged therapy may require multiple punctures
For long durations use distal veins first
Fluid Replacement
Blood
Replaced at a ratio of 3:1 of IV fluid to blood being
replaced
Minimum daily requirements
1st 10 kg
2nd 10 kg
3rd 10 kg
4th 10 kg
5th 10 kg
Example
100 ml/hr
50 ml/hr
20 ml/hr
10 ml/hr
10 ml/hr
50 kg patient
100 ml/hr + 50 ml/hr + 20 ml/hr + 10 ml/hr + 10 ml/hr = 190
ml/hr
Contraindications
Distal to a fracture site in a limb
Through damaged or abraded skin
Burns may be an exception if there is no other
accessible site
In an arm affected by a radical mastectomy,
edema, blood clot or infection
In an arm with a fistula for dialysis or a
peripherally inserted control catheter (PICC
Line)
Procedure
Obtain consent and explain rationale for IV therapy
Assess that the pt meets the criteria for the procedure
Ensure that there are no contraindications for the procedure
Observe universal precautions for body substance exposures
Prepare all necessary equipment
Position the patient
Apply a tourniquet 3 – 5 inches above the selected site
Select the most appropriate venipuncture site
Patient may make a fist to assist in engorging the vein
Condition
Location
Purpose
Duration
Prepare the pt’s arm using alcohol swab
Procedure
Insert needle through skin
Should be at an 30° angle
Lower angle (15°)and enter vein
Observe flashback
Enter vein a ‘little bit more’
Enter catheter into vein
Release tourniquet
Withdraw needle and discard in sharps container,
tamponade the vein to avoid blood spill
Attach iv tubing and open flow valve observing for
infiltration
Cover with Op site or other sterile dressing, tape in
place
IV Access
Complications
Local complications
Hematomas
Infiltration
Necrosis
Thrombophlebitis
Systemic complications
Pulmonary edema
Speed shock
Pyrogenic reaction
Pulmonary embolism
blood
Air
Catheter shear
Local - Hematomas
Causes:
Punctured vein
Symptoms:
Bruising
Tenderness
Swelling
Preventative
actions:
Proper techniques
Local - Infiltration
Causes:
Poor insertion
techniques
Improper taping
Over active patient
IV slows or stops
Symptoms:
Swelling or hardness
Feeling of coldness
Leaking at the site
Preventative actions:
Armboards, proper
taping
Routine checks of IV
flow and site
Local - Necrosis
Causes:
Symptoms:
Preventative actions:
Irritation of tissues
from infiltrated drug or
fluid
Swelling, tenderness
Inflammation or
bruising
Routine checks
Report any changes
Local - Thrombophlebitis
Causes:
Trauma to endothelium
from chemical means
Symptoms:
Pain, redness, swelling
along infected vein
Generalized symptoms
such as fever, malaise,
rapid pulse
Preventative actions:
Avoid insertion over joint
Select veins with adequate
blood flow for infusions of
hypertonic solutions
Systemic – Pulmonary Edema
Causes:
Circulatory overload from
too rapid infusion when
patient has impaired renal
or cardiac function
Symptoms:
JVD, ↑BP, ↑Resps,
dyspnea, agitation
Watch rate
Oxygen, sit pt upright
Slow IV and contact OLMC
Preventative actions:
Systemic – Speed Shock
Causes:
IV running to rapidly
Rapid injection of a
drug
Symptoms:
↓BP, rapid pulse
Labored resps,
cyanosis
Faint, ↓LOC
Preventative actions:
Use controlled volume
infusion set
Upon initiation, ensure
free flowing prior to
rate adjustment
Systemic – Pyrogenic
Reaction
Causes:
Contaminated IV solutions
Symptoms:
Symptoms generally occur
after IV begun
↑temp, chills, headache,
N/V, circulatory collapse
Preventative actions:
Check IV fluids for
cloudiness and particles
Use fresh open IV’s
Systemic – PE
(Blood/Embolus)
Causes:
Unfiltered blood
Partially dissolved drug
Particulate matter in IV
solution
Symptoms:
Dyspnea, cyanosis, pain,
anxiety, tachycardia,
tachypnea
Preventative actions:
Infuse blood through filter
Dissolve drugs completely
Use good judgment when
syringing IV’s
Systemic – PE (Air)
Causes:
Failure to clear tubing of air
Allowing air to enter the
system
Symptoms:
Cyanosis, ↓BP, weak,
tachycardia, ↓LOC, nonspecific chest or ABD pain
Preventative actions:
Don’t let IV run dry
Clear tubing properly
Check syringe prior to injecting
If occurs place pt on left side
and contact OLMC
Troubleshooting
If blood begins to flow back in the IV tubing
If your IV does not run…
Start at the top, work your way back to the patient
Is the bag empty?
Check the IV set clamps to insure they are open
Check tubing for kinks
Check site for any problems
Check location of the bag to insure it is in a gravity flow location
Insure all valves are open
If continues, reassess site and assure arterial cannulation has
not occurred
Blood backing up
Infiltration
Do you need to flush the site
Is your tourniquet still one!
External Jugular (EJ) cannulation
EJ’s
Often used in severe cases of shock,
unresponsiveness and cardiac arrest since
they are HUGE and relatively easy to
cannulate.
Why are they not commonly used in those
who are conscious ?
Why are they not a good choice for patients
of multi system trauma ?
EJ cannulation procedure
Place patient supine / slight reverse Trendelenburg
Why ???
Turn patients head slightly to opposite side
Cleanse with antiseptic using universal precautions
Create tourniquet effect with fingers by applying light
pressure to the inferior aspects of the EJ being
cannulated.
Procedure
Aim needle towards ipsilateral nipple
Insert needle and enter vein
Observe flashback
Withdraw needle and attach IV tuning
Cover site with sterile dressing
EJ cannulation
Calculating flow rates
Volume to be administered (ml) X
Drip set (gtts/ml)
=
Time to be infused (min)
Drip sets
10 gtt/ml (macro)
15 gtt/ml
20 gtt/ml
60 gtt/ml (micro)
10 drops = 1 ml
15 drops = 1 ml
20 drops = 1 ml
60 drops = 1 ml
Drops/min
(gtts/min)
Factor
6
4
3
1
Calculations
Your patient is to receive 1000 ml of normal saline
(NS) over a 12 hour period using a microdrip (60
gtt/ml) administration set. The formula will now look
like this:
Volume to be administered (ml) X
Drip set (gtts/ml)
=
Drops/min
(gtts/min)
=
Drops/min
(gtts/min)
=
Drops/min
(gtts/min)
Time to be infused (min)
1000 ml
X
60 gtts/ml
720 min
83.333
Now add medications
A physician orders 2 mg/min of
Lidocaine to your patient. She orders
2 g of lidocaine to be added to 500 ml
NaCL. Using a 60 gtt/ml set, calculate
the gtt/min.
Calculation
[]
=
Mass
Volume
=
2.0 g
500 ml
Dose
=
D X V
H
=
2 mg/min X 500 ml
2000 mg
=
2000 mg
500 ml
=
=
4 mg/ml
=
1000 mgml/min
2000 mg
0.5 ml/min
Calculation
Volume to be administered (ml) X
Drip set (gtts/ml)
=
Drops/min
(gtts/min)
=
Drops/min
(gtts/min)
=
Drops/min
(gtts/min)
Time to be infused (min)
0.5 ml
X
60 gtts/ml
1 min
30
A Variation to the Same
Volume (ml) X Ordered (mg/min)
X
Drip set (gtts/ml) =
On Hand (mg)
500 ml
X
2 mg/min
X
60 gtt/ml
=
Drops/min
(gtts/min)
=
Drops/min
(gtts/min)
200 mg
30
Drops/min
(gtts/min)