Transcript Slide 1

Chapter 21: Molecules in motion
• Diffusion: the migration of matter down a concentration gradient.
• Thermal conduction: the migration of energy down a temperature
gradient.
• Electric conduction: the migration of electric charge along an
electrical potential gradient.
• Viscosity: the migration of linear momentum down a velocity
gradient.
• Effusion: the emergence of a gas from a container through a small
hole.
21.1 The kinetic model of gases
• Three assumptions:
1. The gas consists of molecules of mass m in ceaseless random
motion.
2. The size of the molecules is negligible, in the sense that their
diameters are much smaller than the average distance traveled
between collisions.
3. The molecules interact only through brief, infrequent, and
elastic collisions.
(Elastic collision: a collision in which the total translational kinetic
energy of the molecules is conserved.)
Pressure and Molecular speeds
•
PV = 1/3 nMc2
(21.1)
where M = mNA, the molar mass of the molecules,
c is the root mean square speed of the molecules:
c = < v2 >1/2 (21.2)
Relationship between the temperature and the root mean
square speed
• Provided that the root mean square speed of the molecules depends
only on the temperature:
pV = constant
at constant temperature
• In comparison with Boyle’s law, one gets
1/ 2
3
RT


c= 
(21.3)

 M 
• The root mean square speed of the gas molecules is proportional to
the square root of the temperature and inversely proportional to the
square root of the molar mass.
Maxwell distribution of speeds
•
 M 
f (v)  4 

 2RT 
3/ 2
v 2 e Mv
2
/ 2 RT
(21.4)
Fraction in the range v1 to v2 equals
v2
v
1
f (v )dv
Expression of molecular speeds
1/ 2
 8RT 


 M 
•
Mean speed
•
The most probable speed
 2 RT 
c*  

 M 
•

c
=
1/ 2
Relative mean speed:
_
c rel  2
1/ 2

1/ 2
 8kT 

c  
  
_
m A mB
m A  mB
(reduced mass)
Measuring molecular speed
The collision frequency
•
Collision diameter: the actual diameter of the molecule.
•
Collision frequency (z): the number of collisions made by one molecule
divided by the time interval during which the collisions are counted.
•
Collision cross-section: σ = πd2
•
_
Z =  c rel 


 crel P
kT
Mean free path
• Mean free path, λ, the average distance a molecule travels between
collisions.
_
 
c
z

kT
21 / 2 P
• Note: The mean free path is independent of the temperature in a
sample of gas in a container of fixed volume!!!
• The distance between collisions is determined by the number of
molecules present in the given volume, not by the speed at which
they travel.
21.2 Collisions with walls and
surfaces
• The collision flux, Zw, the number of collisions with the area in a
given time interval divided by the area and the duration of the
interval.
p
Zw 
(2mkT)1 / 2
• Collision frequency can be obtained by multiplication of the collision
flux by the area of interest.
• Justification of the collision flux:
21.3 The rate of effusion
• Graham’s law of effusion: the rate of effusion is inversely
proportional to the square root of the molar mass.
rate of effusion  Z w A0 
pA0
(2mkT)1 / 2

pA0 N A
(2MRT )1 / 2
• Vapor pressures of liquids and solids can be measured based on the
above equation.
• Example: Derive an expression that shows how the pressure of a gas
inside an effusion oven varies with time if the oven is not replenished as the
gas escapes.
Solution: step 1: the rate of change of pressure in the container is
related to the rate of change of the number of molecules
kTN
P= V
step 2: calculate the derive of P:
dP kT dN

dt
V dt
step 3: the rate of change of the number of molecules is equal to the
collision frequency with the hole multiplied by the area of the hole:
dN
pA0
  Z w A0  
( 2mKT )1 / 2
dt
so
1/ 2
dP
 kT 
 

dt
 2m 
PA0
V
step 4: integrate the above equation
P = P0e-t/τ
1/ 2
 2m 

 kT 
 
V
A0
(Remark: how does the temperature (or the size of the hole) affect the
decrease of pressure?)
Example 24.3b Cesium (m.p. 29oC, b.p. 686 oC) was introduced into a
container and heated to 500 oC. When a hole of diameter 0.500mm
was opened in the container for 100s, a mass loss of 385 mg was
measured. Calculate the vapor pressure of liquid cesium at 500K.
Solution: Despite the effusion, the vapor pressure is constant inside
the container because the hot liquid metal replenishes the vapor.
Consequently, the effusion rate is constant!
The mass loss Δm in an interval Δt is related to the collision flux by:
Δm = ZwA0mΔt
atom.
Where A0 is the area of the hole and m is the mass of one
m
A0 mt
Zw =
p
(2mkT)1 / 2

m
A0mt
plug in numbers, one gets p = 11k Pa