Slide 1 - Helios
Download
Report
Transcript Slide 1 - Helios
AC Circuits
PH 203
Professor Lee Carkner
Lecture 23
Alternating Current Issues
Voltage and current vary sinusoidally with
time
Voltage and current will have a frequency and
angular frequency
w in radians per second
Need to create a more general form of resistance
Circuits have natural oscillation frequencies
May get resonance
Generators
We can use induction to produce a
continuous source of current
Turn a wire loop in a magnetic field with an
external source of work to make a generator
Produces alternating current
Thus the current flows in one direction and then
the other
Characterized with angular frequency wd
Alternating Current
e = emax sin wdt
As the loop makes one
complete rotation (wt goes
from 0 to 2p radians) the
emf goes from 0, to
maximum +, to maximum -,
and back to zero again
The current through the loop
goes one way and then the
other, sometimes is weak
and sometimes is strong
Frequency
The number of these cycles made per second is
the frequency f = wd/2p
We can also refer to the period, the number of
seconds per cycle
T = 1/f = 2p/wd
Note that if wd is similar to the w of the circuit we
have resonance and large current amplitudes are
possible
AC Circuit Elements
Resistors (Resistance, R)
Capacitors (Reactance, XC)
Inductors (Reactance XL)
Current and voltage may not be in phase
Resistors and AC
Resistor connected to an AC generator
Voltage through the circuit varies as the emf of
the generator does
vR = VR sin wdt
We can then find the maximum current with
Ohm’s Law
VR = IRR
Resistors and Phase
When v is max, i is
max
iR = IR sin wdt
Capacitors and AC
As charge builds up on the capacitor, the potential
difference across it increases, decreasing the
current
The capacitor is constantly being charged
and discharged
In a AC circuit the current will vary with some
average rms value that depends on the voltage
and the capacitance
Capacitive Reactance
We define the capacitive reactance to symbolize
this “resistance”:
XC = 1/(wdC)
VC = ICXC
Note that the current depends on the frequency
At high frequency the capacitor never gets much charge
on it
Capacitors and Phase
When the voltage is zero, the
current is a maximum
As voltage increases current
decreases
We say the voltage lags the
current by 90 degrees or ¼ cycle
The equation for current is then
iC = IC sin (wdt + p/2)
Capacitor Power
Since P = vi, we can see if the power is positive
or negative based on the sign of i and v
P is positive half the time and negative half the
time
The capacitor draws energy from and returns
energy to the generator in equal measure
Inductive Reactance
XL = wdL
The inductor is most “effective” at high frequency
due to the rapid current changes
The maximum voltage is again the generator
emf and is related to the maximum current by:
VL = ILXL
Inductors and Phase
look at the slope of the current sine
wave
The induced voltage is zero when
the current is a maximum (since
that is where the current is not
changing)
The current at any time is:
iL = IL sin (wdt – p/2)
Reactance and Frequency
Resistor
Capacitor
Low current at
low frequency
Inductor
Next Time
Read 31.9-31.11
Problems: Ch 31, P: 32, 33, 34, 41, 53
For an LC oscillator when the current
through the inductor is zero, the
charge on the capacitor is,
A)
B)
C)
D)
E)
Maximum
Zero
½ maximum
p maximum
2p maximum
For an LC oscillator the direction of
current in the circuit is,
A) Always in one direction
B) In one direction for one complete cycle
and then the other direction for the
next complete cycle
C) In one direction for ½ of the cycle
and then the other direction for the
other ½ of the cycle
D) Changing direction 2p times per cycle
E) Fluctuating unpredictably
For an LC oscillator when the energy in
the capacitor is ½ maximum the
energy in the inductor is,
A)
B)
C)
D)
E)
Maximum
Negative maximum
Zero
½ maximum
2p maximum