Transcript Solar Energy - Photovoltaics - Faculty

Solar Energy - Photovoltaics
UTI-111
Prof. Park
Essex County College
Energy from the Sun
• The sun’s outer surface, called the
photosphere, radiates energy iin the form
of light and heat.
• The sun’s inner core is composed of
primarily of dense Hydrogen and Helium at
a temperature of approximately 27 million
F. The light and heat from the sun is
produced when these gases undergo
fusion.
Energy from the Sun
• Of the total energy from the sun that
reaches the earth, about 30% is reflected
back to space, 47% is absorbed and
converted to heat and 23% drive the water
cycle.
• The solar energy that the earth received is
called insolation.
Conversion of Solar Energy
• Conversion of solar energy into electrical
energy involves the use of solar cells.
• Solar cells, also called photovoltaics (PV),
convert sunlight directly into electricity.
• For example, a calculator can be powered
by solar cells.
History of PV
• In 1839, French physicist Edmond Becquerel
(3/24/1820 – 5/11/1891) discovered the process
of using sunlight to produce an electric current in
a solid material.
• In 1883, New York electrician Charles Edgar
Fritts, constructed a selenium solar cell and filed
a patent.
• In 1953, Bell Lab researchers Chaplin-FullerPearson team produced doped silicon solar cells
with an efficiency of 6%.
Photoelectric Effect
• The Photoelectric Effect is the physical process
by which a PV cell converts sunlight into
electricity.
• When light strikes a PV cell, it may be reflected,
absorbed, or pass through.
• The light that is absorbed produces electricity.
• The light energy absorbed by the PV excites the
electrons in the atoms of the PV cell. The
electrons escapes from their original positions in
the atoms of the semiconductor material and
becomes part of the electrical flow, or current, in
an electrical circuit.
PV Cells Construction
• To induce the built-in electric field within a PV cell, two
layers of different semiconductor materials are placed in
contact with one another.
• The conductivity of semiconductor increases with
temperature and in the presence of impurities.
• The addition of these impurities is called doping.
• In a PV cell, photons are absorbed in the p-layer. It is
important to optimize this layer to the properties of
incoming photons to absorb as many as possible, and
thus, to free up as many electrons as possible while
keeping the electrons from meeting up with holes and
recombining with them before they can escape from the
PV cell.
PV Cells Construction
• Electrical contacts are essential to a PV cell because
they bridge the connection between semiconductor
material and the external electrical connection.
• The back contact of a cell consists of a layer of
aluminum or molybdenum.
• The front contact is complicated by the need to design a
low resistance point that will collect the maximum
current.
• To do this, contacts must be placed across the entire
surface of a PV cell.
• This is normally done with a gird of metal strips or
fingers. Since this grid will absorb light, the design must
balance shading and electrical losses.
Solar Cells, Modules, and Arrays
• Solar cells are typically combined into modules that hold
about 40 cells; About 10 of these modules are mounted
in a PV arrays that can measure up to several meters on
a side.
• These PV arrays can be mounted at a fixed angle facing
south, or they can b mounted on a tracking device that
follows the sun, allowing them to capture the most
sunlight over the course of a day.
• About 10 to 20 PV arrays can provide enough power for
a household; for a large utility or industrial applications,
hundreds of arrays can be interconnected to form a
single large system.
Performance of Solar Cells
Regional Ranking of Global PV Cell Production in 2008
(Crystalline and Thin Film, Percentage Ranking by Production in Watts)