Transcript HVCMOS_sensor - Indico

Rad-Hard Active Pixel Sensors for
HL-LHC Detector Upgrades
based on HV-CMOS
Marlon Barbero – Centre de Physique des Particules de Marseille
[email protected]
Genova visit / December 16th 2013
ATLAS tracker upgrade plan
 New insertable b-layer
(IBL)
 New Al beam pipe
 New pixel services
 Fast TracKing (FTK)
for level2 trigger
 All new tracker (baseline:
long strips /short strips /
pixels)
 Possible level1 tracker
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
2
HL-LHC environment challenge
• HL-LHC targets:
– 14TeV; Luminosity: 5.1034 cm-2.s-1 / 3000 fb-1 in ~7 years
• Consequences for trackers:
– High radiation for the innermost layers (~5cm):
• ~1.1016 neq.cm-2 / ~1GRad  rad-hardness!
(note: ~50-100MRad at 25cm)
– High occupancy:
• cope with of order <140> pile-up events / bunch-crossing
 high granularity! fast!
– Huge surface to cover:
• of order 200m2  reduction in costs!
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
3
Using Hybrid Detectors
• Hybrid detectors:
– n-in-n or n-in-p with reduced drift distance (3D or thin
silicon).
– DSM rad-hard IC (a la IBL FE-I4 -130nm- or reduced feature
size 65nm?).
– Valid option: should work (after development).
– Drawback: 1- Price of hybridization / of non-standard sensors
(yield?) and for a large area.
2- Will stay rather thick.
3- High bias voltage.
4- Deep charge collection leads to difficult 2-track
separation in boosted jets.
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
4
Principle of HV-CMOS process
• An n-well in p-substrate diode, populated with CMOS
(first stage amplifier or more complex).
CMOS! e.g. 1st
stage amplifier
n-well in p-substrate diode
n-well biasing
depletion zone around
nwell: charge collected
by drift
resist~10Ω.cm
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
5
ATLAS HV-CMOS Collaboration
• Bonn University: M. Backhaus, L.Gonella, T. Hemperek, F. Hügging, H.
Krüger, T. Obermann, N. Wermes.
• CERN: M. Capeans, S. Feigl, M. Nessi, H. Pernegger, B. Ristic.
• CPPM: M. Barbero, F. Bompard, P. Breugnon, JC. Clemens, D. Fougeron,
J. Liu, P.Pangaud, A. Rozanov.
• Geneva University: D. Ferrere, S. Gonzalez-Sevilla, G. Iacobucci, A.
Miucci, D. Muenstermann.
• Goettingen University: M. George, J. Grosse-Knetter, A. Quadt, J.
Rieger, J. Weingarten.
• Glasgow University: R. Bates, A. Blue, C. Butter, D. Hynds.
• Heidelberg University: I. Peric (original idea).
• LBNL: M. Garcia-Sciveres.
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
6
Process Main Characteristics
• CMOS electronics inside deep n-well.
• Negatively biased substrate leads to ~8-10μm depletion zone  charge
collection by drift.
• Small feature size + relatively low complexity of in-pixel logic  small
pixel.
• 1st stage signal amplification on-sensor (low capacitance  low noise).
• Featuring: 1- electronics rad-hard (DSM technology).
2- sensor rad-hard (small depletion depth, small ΔNeff).
3- low price (standard CMOS process).
4- low material budget (can be thinned down).
5- low maximum bias voltage (moderate substrate resistivity).
6- fast (electronics on sensor).
7- good granularity (1st prototype 33×125μm2, can go down).
• HV2FEI4p1/-p2 in AMS180nm HV-CMOS.
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
7
HV2FEI4 series
•
•
•
•
•
•
-p1: Proof of principle.
-p2: Rad-hardness enhanced.
2.2×4.4 mm2.
60columns×24rows.
pixels: 33×125μm2.
pads to realize various
operation modes:
IO for CCPD
strip pads
pixel array w.
transmission pads
– Standalone measurement possible.
– CCPD: Capacitively coupled to pixel IC.
IO for strips
– Bonded to strip readout IC.
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
8
Readout -a la strips• Readout: use HV-CMOS sensor in
combination with existing powerful IC by
connecting HV-CMOS pixels in various
ways.
• e.g. pixels can be summed up as “virtual
strips”, with hit position encoded as pulse
height.
180
160
140
120
Counts
100
80
Pixel hit map from strip information
(note the shadow of a wire)
60
40
20
0
-20
0,0
0,5
1,0
1,5
2,0
Measured analog address [V]
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
9
Readout -with larger pixels• Combine 3 pixels together to fit one FE-I4 pixel (50×250μm2), with
HVCMOS pixels encoded by pulse height.
• Capacitive coupling OK: gluing!
(perspective to avoid bump-bonding?)
The tiny HV2FEI4p1 prototype
glued on the large FE-I4
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
10
HV2FEI4p1 on FEI4
• 90Sr-source.
• Readout through FE-I4.
• kHz rate recorded!
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
11
Sub-pixel encoding principle
unirradiated sensor
• Works on single pixel cells.
• Sub-addresses well separated in ToT histo.
Sub-pixel 1
Sub-pixel 2
3 sub-pixels on
Three values for the addresses decoded
by
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
the FE-I4 pixel
Sub-pixel 3
12
HV2FEI4p1
• Recorded routinely 90Sr and 55Fe
spectra.
Discri
• Degradation at 80MRad proton
irradiation (dead at 200MRad!)
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
13
Bulk damage
• Small depletion depth + Neff > 1014.cm-3 bulk rad-hard?
• Non-ionizing radiation at neutron source (Ljubljana) to
occupancy in
1.1016 neq.cm-2.
No source
leakage current increase
(as expected)
10 minutes
With 90Sr
sensor works at room T after 1016
neq.cm-2. (scintillator trigger used)
Note: 30 days annealing at room temp
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
14
TID issue HV2FEI4p2
• Few pixel flavors with enhanced rad-hardness: guard rings,
circular transistors… (different pixel types lead to different
gains -expected-).
55Fe
spectra, unirradiated
“rad-hard”
“normal”
different gains
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
15
TID issue HV2FEI4p2
• After 862 MRad Xray (annealing included 2h at 70C each
100MRad), after parameter retuning, amplifier gain loss
recovered to 90% of initial value
Relative preampli amplitude variation as function of dose
Recovery at 862
MRad (NOT
900MRad)
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
16
Conclusion
• Principle: Firmly established. Various types of readout
demonstrated, among which capacitive coupling through
gluing to FE-I4.
• Prospects for: Small pixels, less material, cheaper, large area…
• Need further studies on radiation hardness, but
positive indications of radiation tolerance.
• Need efficiency / spatial resolution studies  test
beam.
• Need optimization to establish geometry & architecture.
• Discussion on new larger size prototype to realize currently
on-going.
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
17
Outlook
• Hybrid solution vs monolithic for future trackers? 65nm vs
HVCMOS?
• Our collaboration has started to look into other processes:
Super
Contact
M1
M2
M3
M4
M5
T3-MAPS (LBNL)
IBM 130nm
M5
M4
M3
M2
M1
M
M
6
6
Bond
Interface
Tie
r2
sensor
Tier 1
(thinne
d wafer)
Back Side
Metal
Super
Contact
GFMAPS (CPPM)
GF 130nm
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
1640 electrons (assuming
collected by one pixel)
DMAPS (Bonn)
ESPROS 150nm
18
BACKUP
• BACKUP
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
19
New monolithic sensors on a fully isolated substrate
Spectrum of Fe55 (X-ray) and Sr90 (e-), obtained from a
10mX10m single pixel.
We have exploited a new CMOS substrate isolation implant to
implement a monolithic radiation detector. Because the
substrate is completely junction-isolated from the active wells,
it can be biased at larger negative voltages than would be
possible in a standard process. This not only permits true 100%
fill factor but also improves the sensor performance.
Preliminary results will be shown.
20
Outlook another 3D approach
• We submitted on June 2013 a new HV2FEI4 version in
GlobalFoundries 0.13µm BCDLite technology. The chip
is 100% compatible with the HV2FEI4 chip, and could be
easily tested. Despite some small failures, the chip works
Back Side
Metal
at -30V
sensor
Tier 1
(thinne
d
wafer)
Super
Contact
M5
M4
M3
M2
M1
M6
M6
Bond
Interface
Tie
r2
M1
M2
M3
M4
M5
Super
Contact
• The HV2FEI4 could be use on a complex and advanced
monolithic 3D chip, including analog sensor and digital
post-processing parts
Marlon Barbero, Genova visit to CPPM, Dec. 16th 2013
21
EPCB01 – Depleted monolithic pixel chip
Features:
 Technology:
ESPROS
 Feature size:
CMOS 150 nm
 High resistive N-type bulk (~ 2 kΩ cm)
 High voltage at sensor domain possible (~ 10 V)
Full depletion can be achieved
 P-type well to integrate CMOS electronics
 6 metal layers
 Chip is thinned down to 50 µm
New Physicist’s dream??
17th September 2013, Future Pixel FE meeting
22
Source scan
Fe55

Fe55 used for calibration of Sr90 plot

Sr90 MPV ~2400 electrons
(~ 4200 electrons expected for
~ 50 µm silicon)
→ rest of the charge is collected by
other pixels (clustering)
17th September 2013, Future Pixel FE meeting
23