Transcript integrals of motion

Lecture 08 - ASTC25
Elements of Celestial Mechanics
Part 2 INTEGRALS OF MOTION
1. Energy methods (integrals of motion)
2. Zero Vel. Surfaces (Curves) and the
concept of Roche lobe
3. Roche lobe radius calculation
4. Lagrange points and their stability
5. Hill problem and Hill stability of orbits
6. Resonances and stability of the Solar
System
Non-perturbative methods
(energy constraints, integrals of
motion)
Karl Gustav Jacob Jacobi (1804-1851)
Solar sail problem again
A standard trick
to obtain energy
integral
Energy criterion guarantees that a particle cannot cross the
Zero Velocity Curve (or surface), and therefore is stable
in the Jacobi sense (energetically).
However, remember that this is particular definition of stability
which allows the particle to physically collide with the massive
body or bodies -- only the escape from the allowed region
is forbidden! In our case, substituting v=0 into Jacobi constant,
we obtain:
Allowed regions of motion in solar wind (hatched) lie within the
f=0
f=0.051 < (1/16) Zero Velocity Curve
particle cannot
escape from the
planet located at
(0,0)
f=0.063 > (1/16)
f=0.125
particle can (but
doesn’t always do!)
escape from the
planet
(cf. numerical
cases B and C, where
f=0.134, and 0.2, much
above the limit of f=1/16).
Circular Restricted 3-Body Problem (R3B)
L4
L3
Joseph-Louis Lagrange (1736-1813)
[born: Giuseppe Lodovico Lagrangia]
L1
L2
L5
“Restricted” because the gravity of particle moving around the
two massive bodies is neglected (so it’s a 2-Body problem plus 1 massless
particle, not shown in the figure.)
Furthermore, a circular motion of two massive bodies is assumed.
General 3-body problem has no known closed-form (analytical) solution.
NOTES:
The derivation of energy (Jacobi) integral in R3B does not differ
significantly from the analogous derivation of energy
conservation law in the inertial frame, e.g., we also form the
dot product of the equations of motion with velocity and
convert the l.h.s. to full time derivative of specific kinetic energy.
On the r.h.s., however, we now have two additional accelerations
(Coriolis and centrifugal terms) due to frame rotation (non-inertial,
accelerated frame). However, the dot product of velocity and the
Coriolis term, itself a vector perpendicular to velocity, vanishes.
The centrifugal term can be written as a gradient of a
‘centrifugal potential’ -(1/2)n^2 r^2, which added to the usual sum
of -1/r gravitational potentials of two bodies, forms an effective
potential Phi_eff. Notice that, for historical reasons, the effective
R3B potential is defined as positive, that is, Phi_eff is the sum of
two +1/r terms and +(n^2/2)r^2
n
Effective potential in R3B
mass ratio = 0.2
The effective potential of R3B is defined as negative of the usual Jacobi
energy integral. The gravitational potential wells around the two bodies thus
appear as chimneys.
Lagrange points L1…L5 are equilibrium points in the circular
R3B problem, which is formulated in the frame corotating with
the binary system. Acceleration and velocity both equal 0 there.
They are found at zero-gradient points of the effective potential
of R3B. Two of them are triangular points (extrema of potential).
Three co-linear Lagrange points are saddle points of potential.
Jacobi integral and the topology of Zero Velocity Curves in R3B
  m1 /( m1  m2 )
rL = Roche lobe radius
+ Lagrange points
Sequence of allowed regions of motion (hatched) for particles
starting with different C values (essentially, Jacobi constant ~
energy in corotating frame)
High C (e.g., particle
starts close to one of
the massive bodies)
Highest C
Medium C
Low C (for instance,
due to high init.
velocity)
Notice a curious fact:
regions near L4 & L5
are forbidden. These
are potential maxima
(taking a physical, negative
gravity potential sign)
  m1 /( m1  m2 )
= 0.1
C = R3B Jacobi constant with v=0
Édouard Roche (1820–1883),
Roche lobes
terminology:
Roche lobe ~
Hill sphere ~
sphere of influence
(not really a sphere)
Stability around the L-points
Is the motion around Lagrange points stable?
Stability of motion near L-points
can be studied in the 1st order
perturbation theory
(with unperturbed motion
being state of rest at
equilibrium point).
Stability of Lagrange points
Although the L1, L2, and L3 points are nominally unstable,
it turns out that it is possible to find stable and nearly-stable
periodic orbits around these points in the R3B problem.
They are used in the Sun-Earth and Earth-Moon systems for
space missions parked in the vicinity of these L-points.
By contrast, despite being the maxima of effective potential,
L4 and L5 are stable equilibria, provided M1/M2 is
> 24.96 (as in Sun-Earth, Sun-Jupiter, and Earth-Moon cases).
When a body at these points is perturbed, it moves
away from the point, but the Coriolis force then bends the
trajectory into a stable orbit around the point.
Observational proof of the stability of triangular equilibrium
points
Greeks, L4
Trojans, L5
From: Solar System Dynamics, C.D. Murray and S.F.Dermott, CUP
Roche lobe radius depends weakly on R3B mass parameter
  m1 /( m1  m2 )
= 0.1
  m1 /( m1  m2 ) = 0.01
Computation of Roche lobe radius from R3B equations
of motion (   x / a , a = semi-major axis of the binary)
L
Roche lobe radius depends weakly on R3B mass parameter
 1/ 3
rL  ( 3 ) a
  m1 /( m1  m2 )
= 0.1
  m1 /( m1  m2 ) = 0.01
m2/M = 0.01 (Earth ~Moon) r_L = 0.15 a
m2/M = 0.003 (Sun- 3xJupiter) r_L = 0.10 a
m2/M = 0.001 (Sun-Jupiter) r_L = 0.07 a
m2/M = 0.000003 (Sun-Earth) r_L = 0.01 a
Hill problem
rL  rL  ( 3 )1/ 3 a
George W. Hill (1838-1914) - studied the small mass ratio
limit of in the R3B, now called the Hill problem. He ‘straightened’ the
azimuthal coordinate by replacing it with a local Cartesian coordinate y,
and replaced r with x. L1 and L2 points became equidistant from the planet.
Other L points actually disappeared, but that’s natural since they are not
local (Hill’s equations are simpler than R3B ones, but are good approximations
to R3B only locally!)
Roche lobe ~ Hill sphere ~ sphere of influence (not
really a sphere, though)
Hill problem
rL  rL  ( 3 )1/ 3 a
Hill applied his equations to the Sun-Earth-Moon problem, showing
that the Moon’s Jacobi constant C=3.0012 is larger than CL=3.0009 (value of
effective potential at the L-point), which means that its Zero Velocity Surface
lies inside its Hill sphere and no escape from the Earth is possible:
the Moon is Hill-stable.
However, this is not a strict proof of Moon’s eternal stability because:
(1) circular orbit of the Earth was assumed (crucial for constancy of Jacobi’s C)
(2) Moon was approximated as a massless body, like in R3B.
(3) Energy constraints can never exclude the possibility of Moon-Earth collision
COMPARISON OF THEORIES
From the example of Sun-Earth-Moon system we find that:
integrals of motion guarantee no-escape from the allowed
regions of motion for an infinite period of time, which is better
than either the general or the special perturbation theory can do
but only if the assumptions of the theory are satisfied, and
that’s difficult to achieve in practice
we are usually only interested in time periods up to Hubble
time. In late 1990s our computers and algorithms became
capable of simulating such enormous time spans.
Numerical exploration has supplanted the elegant 18th-century
methods as the preferred tool of dynamicists trying
to ascertain the stability of the Solar System and its exo-cousins.
(Laplace’s and Lagrange’s analytical methods were OK in their
time, when the biblical age of the Sun/Earth of 4000 yr was
accepted).
So….
Is the Solar System orbitally stable?…
Yes, it appears so (for billions of years),
but we cannot be absolutely sure!
Is the Solar System orbitally stable?…
No certainty, now or ever.
The reason is that, like the weather on Earth, the detailed
configuration of the planets after
1 Gyr, or even 100 mln yrs is
?
impossible to predict or compute.
On Earth, this is because of
chaos in weather systems (supersensistivity to initial conditions,
too many coupled variables)
Hurricane Rita,
Sept. 23, 2005
(weakened unexpectedly fast)
In planetary systems, chaos is
due to planet-planet
gravitational perturbations
amplified by resonances.
Two or more overlapping
resonances can make the precise
predictions of the future futile.
Chaos in:
rotation
oscillation
Double pendulum
Lorentz attractor
(modeled after
weather system
equations)
In the Solar System, resonant angles librate (oscillate)
in 2-body resonances
Strong, non-chaotic resonances in satellite systems
Also planets exhibit such low-order commensurabilities, the most
famous being perhaps the 2:5 Saturn-Jupiter one. (2:3 Pluto-Neptune
resonance does not prevent chaotic nature of Pluto’s orbit.)
Example of chaotic orbits due to overlapping resonances
Orbits and planet positions are unpredictable on a timescale
of 100 mln yrs or less (50 mln yrs for Earth).
For instance, let the longitudes of perihelia be denoted by w
and the ascending nodes as W, then using subscripts E and M
for Earth and Mars, there exists a resonant angle
fME = 2(wM -wE) - (WM -WE)
that shows the same hesitating behavior between oscillation
(libration) and circulation (when resonant lock is broken) as
in a double pendulum experiment.
But chaos in our system is stable for the time ~ its age
Orbits have the numerical, long-term, stability. They don’t cross
and planets don’t exchange places or get ejected into Galaxy.
The only questionable stability case is that of Mercury & Sun.
Mercury makes such wide excursions in orbital elements,
that in some simulations it drops onto the Sun in 3-10 Gyr.
How wide a region is destabilized by a planet?
Hill stability of
circumstellar motion
near the planet
C
rL  rL  ( 3 )1/ 3 a
CL
The gravitational influence of a small body (a planet around a star, for
instance) dominates the motion inside its Roche lobe, so particle orbits
there are circling around the planet, not the star. The circumstellar orbits in the
vicinity of the planet’s orbit are affected, too. Bodies on “disk orbits”
(meaning the disk of bodies circling around the star) have Jacobi constants C
depending on the orbital separation parameter x = (r-a)/a (r=initial circular orbit
radius far from the planet, a = planet’s orbital radius). If |x| is large enough,
the disk orbits are forbidden from approaching L1 and L2 and entering the
Roche lobe by the energy constraint. Their effective energy is not enough to
pass through the saddle point of the effective potential. Therefore, disk
regions farther away than some minimum separation |x| (assuming circular
initial orbits) are guaranteed to be Hill-stable, which means they are isolated
from the planet.
Hill stability of
circumstellar
motion near the
planet
C
CL
On a circular orbit with x = (r-a)/a,
At the L1 and L2 points
C  3  34 x
2
 1/ 3
rL  ( 3 ) a
CL  3  9(rL / a) 2
2
2
x

12
(
r
/
a
)
Therefore, the Hill stability criterion C(x)=CL reads
L
or
x  2 3(rL / a)  3.5 rL / a
Example:
What is the extent of Hill-unstable region around Jupiter?
x  3.5 rL / a  3.5  (0.001/ 3)1/ 3  0.24
Since Jupiter is at a=5.2 AU, the outermost Hill-stable
circular orbit is at
r = a - xa = a - 0.24a = 3.95 AU.
Asteroid belt objects are indeed found at r < ~4 AU
(Thule group at ~4 AU is the outermost large group of
asteroids except for Trojan and Greek asteroids)