Transcript Mutations
Anatomy and Function
of a Gene
Dissection through mutation
1
Outline of Chapter 7
What mutations are
Mutations and gene structure
Experiments using mutations demonstrate a gene is a discrete
region of DNA
Mutations and gene function
How often mutations occur
What events cause mutations
How mutations affect survival and evolution
Genes encode proteins by directing assembly of amino acids
How do genotypes correlate with phenotypes?
Phenotype depends on structure and amount of protein
Mutations alter genes instructions for producing proteins
structure and function, and consequently phenotype
2
Mutations: Primary tools of genetic
analysis
Mutations are heritable changes in base
sequences that modify the information
content of DNA
Forward mutation – changes wild-type to
different allele
Reverse mutation – causes novel mutation to
revert back to wild-type (reversion)
3
Classification of mutations by affect
on DNA molecule
Substitution – base is replaced by one of the other
three bases
Deletion – block of one or more DNA pairs is lost
Insertion – block of one or more DNA pairs is
added
Inversion 180o rotation of piece of DNA
Reciprocal translocation – parts of
nonhomologous chromosomes change places
Chromosomal rearrangements – affect many
genes at one time
4
Fig. 7.2
5
Spontaneous mutations influencing
phenotype occur at a very low rate
Mutation rates from wild-type to recessive alleles for five coat color
genes in mice
6
Fig. 7.3 b
General observations of mutation
rates
Mutations affecting phenotype occur very
rarely
Different genes mutate at different rates
Rate of forward mutation is almost always
higher than rate of reverse mutation
7
Are mutations spontaneous or
induced?
Most mutations are spontaneous.
Luria and Delbruck experiments - a simple
way to tell if mutations are spontaneous or
if they are induced by a mutagenic agent
8
Fig. 7.4
9
Replica plating verifies preexisting
mutations
Fig. 7.5 a
10
Fig. 7.5b
11
Interpretation of Luria-Delbruck fluctuation
experiment and replica plating
Bacterial resistance arises from mutations
that exist before exposure to bactericide
After exposure to bactericide, the
bactericide becomes a selective agent killing
the nonresistant cells, allowing only the
preexisting resistant cells to survive.
Mutations do not arise in particular genes
as a direct response to environmental
change
Mutations occur randomly at any time
12
Chemical and Physical agents cause
mutations
Hydrolysis of a purine
base, A or G occurs 1000
times an hour in every cell
Deamination removes –
NH2 group. Can change
C to U, inducing a
substitution to and A-T
base pair after replication
13
X rays break the
DNA backbone
UV light produces
thymine dimers
Fig. 7.6 c, d
14
Oxidation from free radicals formed by irradiation
damages individual bases
Fig. 7.6 e
15
Repair enzymes fix errors created by
mutation
Excision repair
enzymes
release
damaged
regions of
DNA. Repair
is then
completed by
DNA
polymerase
and DNA ligase
Fig. 7.7a
16
Mistakes during replication alter
genetic information
Errors during replication are exceedingly
rare, less than once in 109 base pairs
Proofreading enzymes correct errors made
during replication
DNA polymerase has 3’ – 5’ exonuclease activity
which recognizes mismatched bases and excises
it
In bacteria, methyl-directed mismatch repair
finds errors on newly synthesized strands and
corrects them
17
DNA polymerase proofreading
Fig. 7.8
18
Methyldirected
mismatch
repair
Fig. 7.9
19
Unequal crossing over creates one
homologous chromosome with a duplication
and the other with a deletion
7.10 a
20
Transposable elements move around the genome
and are not susceptible to excision or mismatch
repair
Fig. 7.10 e
21
Trinucleotide instability causes
mutations
FMR-1 genes in
unaffected people
have fewer than
50 CGG repeats.
Unstable
premutation
alleles have
between 50 and
200 repeats.
Disease causing
alleles have > 200
CGG repeats.
Fig. B(1) Genetics and Society
22
Trinucleotide repeat in people with
fragile X syndrom
Fig. A, B(2) Genetics and
Society
23
Mutagens induce mutations
Mutagens can be used to increase mutation
rates
H. J. Muller – first discovered that X rays
increase mutation rate in fruit flies
Exposed male Drosophila to large doses of X
rays
Mated males to females with balancer X
chromosome (dominant Bar eyed mutation and
multiple inversions)
Could assay more than 1000 genes at once on
the X chromosome
24
Muller’s experiment
Fig. 7.11
25
Mutagens increase mutation rate
using different mechanisms
Fig. 7.12a
26
27
Fig. 7.12 b
28
Fig. 7.12 c
29
Consequences of mutations
Germ line mutations – passed on to next
generation and affect the evolution of
species
Somatic mutations – affect the survival of
an individual
Cell cycle mutations may lead to cancer
Because of potential harmful affects of
mutagens to individuals, tests have been
developed to identify carcinogens
30
The Ames test
for carcinogens
using hismutants of
Salmonella
typhimurium
Fig. 7.13
31
What mutations tell us about gene
structure
Complementation testing tells us whether
two mutations are in the same or different
genes
Benzer’s experiments demonstrate that a
gene is a linear sequence of nucleotide pairs
that mutate independently and recombine
with each other
Some regions of chromosomes mutate at a
higher rate than others – hot spots
32
Complementation testing
Fig. 7.15 a
33
Fig. 7.15 b,c
Five complementation groups (different genes) for eye color.
Recombination mapping demonstrates distance between genes and alleles.
34
A gene is a linear sequence of
nucleotide pairs
Seymour Benzer mid 1950s – 1960s
If a gene is a linear set of nucleotides,
recombination between homologous
chromosomes carrying different mutations
within the same gene should generate wild-type
T4 phage as an experimental system
Can examine a large number of progeny to detect
rare mutation events
Could allow only recombinant phage to proliferate
while parental phages died
35
Benzer’s experimental procedure
Generated 1612 spontaneous point mutations and
some deletions
Mapped location of deletions relative to one
another using recombination
Found approximate location of individual point
mutations by deletion mapping
Then performed recombination tests between all
point mutations known to lie in the same small
region of the chromosome
Result – fine structure map of the rII gene locus
36
How recombination within a gene
could generate wild-type
Fig. 7.16
37
Working with T4 phage
38
Phenotpyic properties of T4 phage
Fig. 7.17 b
39
Complementation test to for
mutations in different genes
40
Detecting recombination between
two mutations in the same gene
Fig. 7.17 d
41
Deletions for rapid mapping of point
mutations to a region of the chromosome
Fig. 7.18 a
42
Recombination
mapping to identify
the location of each
point mutation
within a small
region
Fig. 7.18 b
43
Fine structure map of rII gene
region
Fig. 7.18 c
44
What mutations tell us about gene
function
One gene, one enzyme hypothesis: a gene contains
the information for producing a specific enzyme
Beadle and Tatum use auxotrophic and prototrophic
strains of Neurospora to test hypothesis
Genes specify the identity and order of amino
acids in a polypeptide chain
The sequence of amino acids in a protein
determines its three-dimensional shape and
function
Some proteins contain more than one polypeptide
coded for by different genes
45
Beadle and Tatum – One gene, one
enzyme
1940s – isolated mutagen-induced mutants that
disrupted synthesis of arginine, an amino acid
required for Neurospora growth
Auxotroph – needs supplement to grow on minimal
media
Prototroph – wild-type that needs no supplement; can
synthesize all required growth factors
Recombination analysis located mutations in four
distinct regions of genome
Complementation tests showed each of four
regions correlated with different complementation
group (each was a different gene)
46
Fig. 7.20 a
47
Fig. 7.20 b
48
Interpretation of Beadle and Tatum
experiments
Each gene controls the synthesis of an
enzyme involved in catalyzing the
conversion of an intermediate into arginine
49
Genes specify the identity and order of
amino acids in a polypeptide chain
Proteins are linear polymers of amino acids linked
by peptide bonds
20 different amino acids are building blocks of proteins
NH2-CHR-COOH – carboxylic acid is acidic, amino
group is basic
R is the side chain that distinguishes each amino acid
Fig. 7.21 a
50
R is the side group that distinguishes each
amino acid
Fig. 7.21 b
51
52
Fig. 7.21 b
53
N terminus of a protein contains a free amino group
C terminus of protein contains a free carboxylic acid group
Fig. 7.21 c
54
Genes specify the amino acid sequence of a
polypeptide – example, sickle cell anemia
Mutant b chain of
hemoglobin form
aggregates that
cause red blood
cells to sickle
Fig. 7.22 a
55
Sequence of amino acids determine a proteins
primary, secondary, and tertiary structure
Fig. 7.23
56
Some proteins are multimeric, containing subunits
composed of more than one polypeptide
Fig. 7.24
57
How do genotypes and phenotypes
correlate?
Alteration of amino acid composition of a
protein
Alteration of the amount of normal protein
produced
Changes in different amino acids at
different positions have different effects
Proteins have active sites and sites involved in
shape or structure
58
Dominance relations between alleles depend on the
relation between protein function and phenotype
Alleles that produce nonfunctional proteins are usually recessive
Null mutations – prevent synthesis of protein or promote synthesis of
protein incapable of carrying out any function
Hypomorphic mutations – produce much less of a protein or a protein
with weak but detectable function; usually detectable only in
homozygotes
Incomplete dominance – phenotype varies in proportion to
amount of protein
Hypermorphic mutations – produces more protein or same amount of a
more effective protein
Dominant negative – produces a subunit of a protein that blocks the
activity of other subunits
Neomorphic mutations – generate a novel phenotype; example is ectopic
expression where protein is produced outside of its normal place or time
59