Transcript V Cafe Specifications and Installation

Coffee Dispenser
Specifications
and
Installation Requirements
Specifications and Installation Requirements:
Counter Space
Dimensions:
Width
13 in
(330mm)
Depth
18 1/8
(460mm)
Height 30 in
(770mm)
The space required for Vcafé installation must include a minimum of 4 inches
(102mm) clearance on each side and the back of the unit.
Never mount in a closed cabinet unless the installation space is provided with
ducts and fan to introduce fresh air and remove normal excess heat created
during water heating and refrigeration the concentrate storage compartments.
Specifications and Installation Requirements:
Electrical Requirements
The Vcafé automatically accommodates input voltage from 100 to 240VAC. No
changes to the internal wiring or power supply are required. (How cool is this??)
Only the electical connector and a program selection will require change. The
latter will be covered in the next slide. Specifications with recommended
220 - 240V
breakers and line connectors are:
Voltage
230 VAC
110VAC
Current
Draw
23.5 A
15A
Total
Watts
5400
1650
Circuit
Breaker
Recommended
Connector
30 A
NEMA L630R
NEMA L630P
20 A
NEMA 5-20R
NEMA 5-20P
This system requires two wires plus ground.
Neutral is not used for power connection.
NEMA L630P
NEMA L630R
115 - 120V
NEMA 520R
NEMA 520P
A 20A
NEMA 520P Connector is shown. Parallel
blades are acceptable if rated 20A.
Specifications and Installation Requirements:
Electrical Requirements
The recommended connectors were selected for being almost
universally accepted throughout North America. Others may be
suitable for use in a given locale. Before changing connector styles, be
certain your local electrical codes will consider it acceptable.
Circuit Breakers require rigid adherence to the recommendations on
the previous page. Do not connect the Vcafé to a circuit protected by a
breaker rated lower than these values.
Always confirm the circuit used is protected by the correct breaker
value and that the Vcafé is the only machine using the circuit. Failure
to comply with these basic safety guidelines promotes the possibility of
property loss, injury or even death.
Specifications and Installation Requirements:
Water Filters
Water filters should be used on all coffee dispenser
installations. Making up more than 95% of the finished
drink, taste free water is essential to the quality of any
dispensed beverage.
Contributors to bad tasting water include sediment,
dissolved minerals and chemicals. The most prevalent of
these factors is chlorine and is easily eliminated using a
simple in line or cartridge filter as illustrated here.
The most insidious issues may include all of these factors
and may require a multi stage system to remove
particulates, minerals and chemicals such as iron, sulphur,
lead and more.
Water filtration is a complex specialty and requires
familiarity with local conditions. When required, always
consult a reputable filter vendor for specific needs.
This subject will receive detailed coverage in a course
dedicated to the subject.
Always use a filter!
Specifications and Installation Requirements:
Water Connection Requirements
The Vcafé is fitted with a 3/4” Male Hose Connector requiring a 3/4” Female
Hose Connector X 3/8 MPT fitted to a 3/8” FPT X 3/8” Flare ELL as illustrated
below. A 3/8 water supply line is required for the connection
Water Supply pressure must fall between 10 to 120 psi with a minimum flow
rate of 2 gallons per minute. Verify by running water from the water line into a
bucket for one minute. Any volume greater than 2 gallons is acceptable.
Note:
Due to differences in local health and
plumbing regulations, the Vcafe is not
fitted or supplied with any form of
backflow prevention device.
Water Pipe connections and fixtures
directly connected to a potable water
supply shall be sized, installed and
maintained in accordance with federal,
state and local codes.
3/4” Female Garden
Hose Connector X 3/8
MPT
3/8” Water
Supply Line
3/8” FPT X 3/8
Flare ELL