Transcript 200150 - Desco Industries Inc.

200150
Mini Zero Volt Ioniser
12/2007
©Copyright 2007 Desco Industries Inc.
200150
Mini Zero Volt Ioniser
Description
The 200150 is an ultra-compact and lightweight dual
steady state DC autobalancing benchtop ionser. This
unit is small enough to be installed into almost
any area needing to be neutralized. It may also be wall
or shelf mounted. The ioniser's neutralization time will
be best approximately 30cm to 90cm directly in
front of the unit and will increase as the distance from
the unit increases.
“Various feedback and auto balance techniques are available to ensure ionizer
performance…Providing a sensor for each ionizing device can improve feedback
control. Effective control can reduce the amount of necessary maintenance.
(EN 61340-5-2 clause 5.2.9.2 Monitoring and feedback control)
Vermason.co.uk
200150
Mini Zero Volt Ioniser
Features
• Ultra compact size - 5.25"H x 3.5"W x 1.7"D
• Low offset voltage with feedback alarms
• Two fan speeds, high and low
• Powered by 24 volts DC, AC adapter not included
• Rapid Access Maintenance
• Utilizes steady state DC ionization with Desco Emit's
patented (US Patent #4,974,115) Sense Feedback
Control
• Visual and audible power and alarm indicators
• 1 Year limited warranty
Vermason.co.uk
200150
Mini Zero Volt Ioniser
Operation
Set the fan speed switch on the side of the unit to the
LOW or HIGH position. Higher airflow will result in
faster neutralization rates. Position the unit so
that the maximum airflow is directed at the items or
area to be neutralized. The LED will turn on during
power up and remain GREEN during normal
operation.
Vermason.co.uk
200150
Mini Zero Volt Ioniser
Specifications
• Air Flow: Two speed fan, 500fpm - 300fpm, 34cfm at high fan speed
• Balance: ±5 volts, typical; ±20 volts maximum.
(Temperature range: 65°F to 80°F, R.H.: 15% to 65%)
• Chassis: Stainless Steel Enclosure
• Dimensions ( with stand ): 13.3cm high x 8.9cm wide x 4.3cm deep
• Emitter Points: .050" diameter pure tungsten for improved mechanical strength
and ionization stability.
• High Voltage Power Supplies: 5.5 KV DC nominal.
• Input Power: 24VDC, center positive, 2.5 x 5.5mm power jack
• Ion Emission: Steady state DC with sense feedback.
• Mounting: Tilt adjust frame with three holes that can accommodate up to a
#10 screw.
• Ozone: Less than 0.05ppm
• Weight: 0.4536 kg
Vermason.co.uk
200150
Mini Zero Volt Ioniser
EN 61340-5-2
“Ionizers should be considered as a method for charge neutralization in cases
where grounding cannot be achieved. These may include localized (bench)
ionized air blowers, compressed air ionizers, spot ionizers, tape dispenser
ionizers and total room ionizers.” “Air ionization can neutralize the static charge on
insulated and isolated objects by producing separate charges in the molecules of
the gases of the surrounding air. When a static charge is present on objects in the
work environment, it will be neutralized by attracting opposite polarity charges
from the ionized air. Note that ionization systems should not be used as a primary
means of charge control on conductors or people. As with all ionizers, periodic
maintenance will be needed to provide optimum performance.”
(EN 61340-5-2 clause 5.2.9)
Vermason.co.uk