Transcript 幻灯片1 - Powermaster Marine:Home

 Bridge Navigational
Watch Alarm System
桥楼航行值班报警系统
BNWAS-2000
POWERMASTER MARINE LTD
3~4th floor, #2 Building, No.848 Yunqiao Road,
Jinqiao Export Processing Zone, Shanghai 201206, China
Tel: +86 21 68550150 Fax: +86 21 68556096
上海倍豪船舶科技有限公司
中国上海金桥出口加工区云桥路848号2号楼3~4楼
邮编：201206
电话l: +86 21 68550150 传真: +86 21 68556096
POWERMASTER MARINE LTD
Features 系统特点
 Sunlight viewable LCD
 Friendly operator
interface
 Easy to learn and use
 Steady performance




高亮度LCD显示，日光下
可视
操作界面友好
使用简单
高可靠性
System block diagram 系统框图
System components 系统组成
 Alarm & control panel
 control cabinet (can be installed into operationconsoles).

Alarm acoustic signals buzzers

Alarm Panel

Reset Panels

Some other additional
components






报警控制板
控制接线箱（可以安装在控制台中）
声音报警单元（蜂鸣器）
报警指示板（盒）
复位控制板（盒）
其它组件
Alarm & control panel
报警控制板
Alarm acoustic signals buzzers
声音报警单元
Alarm Panel
报警指示板
Control cabinet
控制接线箱
Reset Panels
复位控制板
Operational modes 工作模式
 Automatic (Automatically brought into operation
whenever the ship’s heading or track control system is
activated and inhibited when this system is not
activated)
 Manual ON (In operation constantly)
 Manual OFF (Does not operate under any
circumstances)



自动模式（船舶航行控制系统运行时自动控制该系统处
于持续工作状态）
手动开启（系统进入持续工作状态）
手动关闭（系统处于关闭状态）
Alarms & indications functions 报警及指示功能
 Visual indication (Once operational, the alarm system
should remain dormant for a period of between 3 and
12 min (Td). At the end of this dormant period, the
alarm system should initiate a visual indication on the
bridge.)
 First stage alarm (If not reset, the BNWAS should
additionally sound a first stage audible alarm on the
bridge 15 s after the visual indication is initiated.)
 Second stage alarm (If not reset, the BNWAS should
additionally sound a second stage remote audible
alarm in the back-up officer’s and/or Master’s location
15 s after the first stage audible alarm is initiated.)





Third stage alarm （If not reset, the BNWAS should
additionally sound a third stage remote audible alarm
at the locations of further crew members capable of
taking corrective actions 90 s after the second stage
remote audible alarm is initiated. In larger vessels, the
delay between the second and third stage alarms may
be set to a longer value on installation, up to a
maximum of 3 min, to allow sufficient time for the
back-up officer and/or Master to reach the bridge.)
灯光提示 （系统启动后，报警计时器开始计时，计时
时间超过设定时间（3~12分钟可调）后，系统输出灯
光提示信号）
一级报警 （系统输出灯光提示后，如果没有被复位，
系统在15秒后输出一级报警声音信号（桥楼区域））
二级报警 （系统输出一级报警后，如果没有被复位，
系统在15秒后输出二级报警声音信号（后备值班驾驶和
船长区域））
三级报警 （系统输出二级报警后，如果没有被复位，
系统在90秒（对于大型船舶，可以最大设置为180秒，
以便二级报警后，后备值班驾驶和船长能及时赶到桥楼
进行报警复位）后输出三级报警声音信号（后备值班驾
驶和船长区域））
Reset functions 复位功能
 It should not be possible to initiate the reset function or
cancel any audible alarm from any device, equipment
or system not physically located in areas of the bridge
providing proper look out.
 A continuous activation of any reset device should not
prolong the dormant period or cause a suppression of
the sequence of indications and alarms.


复位功能只能设置在桥楼能够正常监视到区域
复位功能只在按钮被按下的瞬间被触发，当复位按钮持
续被按下时，计时器将在被复位一次后重新开始计时。
Communication interfaces 通信接口
 Additionally, the BNWAS shall provide an interface
according to IEC 61162-1, ALR sentence.

Security 安全
 Selecting the Operational Mode and the duration of
the Dormant Period (Td) be security protected so that
access to these controls should be restricted to the
Master only.

Emergency call 紧急呼叫
 On the bridge to immediately activate the second, and
subsequently third, stage remote audible alarms by an
‘Emergency Call’ push button.

值班人员能在桥楼启动紧急呼叫按钮触发二及报警，并
按正常时序触发三级报警。
系统提供满足to IEC 61162-1 标准要求的通信接口
系统工作模式转换及系统参数修改功能受密码保护，防
止非被授权人员进行操作。
System failure alarms and indications 系统故障报警
 If a system failure (PLC failure and HMI panel failure)
or power supply failure to the BNWAS is detected, this
should be indicated and extend by external interface.

系统具有完备的自检功能，系统故障时，能输出故障报
警信号。
Specifications 技术参数
 Main supply voltage: 220VAC,50Hz/60Hz
 Backup supply voltage :24 VDC
 Power: 50 watts
 All the test of components of BNWAS according to the
following requirements:




主电源： 220VAC,50Hz/60Hz
备用电源： 24 VDC
电源功率： 50 W
系统及设备满足以下标准要求
Main standards 主要设计标准
 MSC.128(75)-Performance standards for a bridge
navigational watch alarm system(BNWAS)
 IEC62616-Maritime navigation and radio
communication equipment and systems
 IEC60945- Maritime navigation and radio
communication equipment and systems –General
requirements –Methods of testing and required test
results