Transcript SN65LVCPxx – Single Ended Operation

SN65LVCPxx – Single Ended
Operation
Ajinder Singh
SN65LVCPxx – Single Ended Operation
•
•
•
Provide a termination at the end of the line to provide common mode bias. This
voltage could be set based on the input signal range of the receiving device
Use AC coupling value based on the lowest data rate: Use the below formula:
If C is the AC-coupling capacitor and R is total resistance as seen from the capacitor
C = 7.8*N*T/R
–
Here N is the consecutive numbers of identical bits, T is the bit period
SN65LVCPxx – Single Ended Operation –
Simulation Results
•
Single ended swing of ~400mV can be achieved