Transcript Lecture 37

Lecture #37: Memory
• Last lecture:
– Transmission line equations
– Reflections and termination
– High frequency measurements
• This lecture:
– Static Ram
– Dynamic Ram
11/29/2004
EE 42 fall 2004 lecture 37
1
Memory types
• In addition to registers, there is usually a
need in digital logic devices for a denser
(and therefore cheaper) means of storing
information in larger amounts.
• The main memory types are known as
RAM (Random Access Memory) as
contrasted with long shift registers from
which information can only be extracted or
added in sequence.
11/29/2004
EE 42 fall 2004 lecture 37
2
RAM
• In a RAM, an address is provided to a
block of logic, along with an address
strobe and a write signal line.
• The memory block then either reads a
block of bits and puts it onto a bus, or
writes the data from the bus into the
indicated area of memory.
11/29/2004
EE 42 fall 2004 lecture 37
3
Types of memory
• SRAM (Static RAM) is a memory which is
essentially an array of flip flops. It can be
very fast, and is integrated with logic.
• DRAM (Dynamic RAM) is a dense
memory which uses a single capacitor
controlled by a switch to store a bit. Dram
must be rewritten after a write, and must
be refreshed periodically.
11/29/2004
EE 42 fall 2004 lecture 37
4
Other types of memory
• Read only memory (ROM) is a memory whose
content is fixed at manufacture, and thus can
only be read.
• Content addressable memory (CRAM) is
memory which can be addressed, at least in part
by its contents, rather than an address.
• E2 memory (electrically erasable) is memory
which can be read and written, but whose
content is nonvolatile. Writing is often much
slower than reading
11/29/2004
EE 42 fall 2004 lecture 37
5
RAM logical organization
Column Decoder
…
Read/Write
D
Address lines
Address strobe
Row Decoder
…
Q
Memory array
Note that the number row decoder lines and column lines goes like the
square root of the memory size
11/29/2004
EE 42 fall 2004 lecture 37
6
SRAM
• Cache uses SRAM: Static Random Access
Memory
– No refresh
– Size 6 transistors/bit
– Fast, can be optimized for speed or area reduction
– Compatible with dense logic, so can be integrated
with microprocessors with no extra masks
11/29/2004
EE 42 fall 2004 lecture 37
7
Static RAM (SRAM)
• Six transistors in cross connected fashion
– Provides regular AND inverted outputs
– Implemented in CMOS process
11/29/2004
Single Port 6-T SRAM Cell
EE 42 fall 2004 lecture 37
8
SRAM cell
• Each cell of an SRAM is a pair of cross
connected small inverters
• As long as power is supplied, the latch will hold
the value.
• When the row line is held high, the outputs are
driven with the contents of the memory.
• The latch is written by using a more powerful
driver on the column lines to overcome the
smaller transistors in the latch which forces the
desired state.
11/29/2004
EE 42 fall 2004 lecture 37
9
DRAM
• Main Memory is DRAM: Dynamic Random
Access Memory
– 1 transistor
– Dynamic since needs to be refreshed periodically
(8 ms, 1% time)
– Addresses divided into 2 halves (Memory as a 2D
matrix):
• RAS or Row Access Strobe
• CAS or Column Access Strobe
11/29/2004
EE 42 fall 2004 lecture 37
10
Dynamic RAM
• SRAM cells exhibit high speed/poor density
• DRAM: simple transistor/capacitor pairs in high density
form
Word Line
C
.
.
.
Bit Line
Sense Amp
11/29/2004
EE 42 fall 2004 lecture 37
11
Basic DRAM Cell
• Planar Cell
– Polysilicon-Diffusion Capacitance, Diffused Bitlines
• Problem: Uses a lot of area (< 1Mb)
• You can’t just ride the process curve to shrink C (discussed later)
Capacitor
Metal word line
M1 word
line
SiO2
poly
n+
Field Oxide
n+
poly
Inversion layer
induced by
plate bias
Diffused
bit line
Polysilicon
Polysilicon
plate
gate
(a) Cross-section
(b) Layout
Used Polysilicon-Diffusion Capacitance
Expensive in Area
11/29/2004
EE 42 fall 2004 lecture 37
12
DRAM Operations
• Write
– Charge bitline HIGH or LOW and set wordline HIGH
• Read
– Bit line is precharged to a voltage halfway
between HIGH and LOW, and then the
word line is set HIGH.
– Depending on the charge in the cap, the
precharged bitline is pulled slightly higher
or lower.
– Sense Amp Detects change
•
Word
Line
C
.
Bit Line
.
.
The signal is decreased by the ratio of the storage capacitance
to
the bitline capacitance
– Increase density => increase parasitic
capacitance
– As geometries shrink, still need large bit capacitance
11/29/2004
EE 42 fall 2004 lecture 37
Sense
Amp
13
Advanced DRAM Cells
• Stacked cell (Expand UP)
11/29/2004
EE 42 fall 2004 lecture 37
14
Advanced DRAM Cells
• Trench Cell (Expand DOWN)
Cell Plate Si
Capacitor Insulator
Refilling Poly
Storage Node Poly
Si Substrate
2nd Field Oxide
11/29/2004
EE 42 fall 2004 lecture 37
15
DRAM logical organization
(4 Mbit)
Column Decoder
…
Sense Amps & I/O
11
D
A0…A10
Row Decoder
…
Q
Memory Array
(2,048 x 2,048)
Storage
Word Line Cell
• Square root of bits per RAS/CAS
11/29/2004
EE 42 fall 2004 lecture 37
16
DRAM sense amp
+V
enable
enable
Both precharged to ½ V
Bit line
Data out
enable
11/29/2004
enable
EE 42 fall 2004 lecture 37
17
DRAM sense amplifier
• The reason that DRAM is slow, is that a very small
charge is captured on the capacitor, and the small
voltage change on the line must be sensed.
V
Precharge→
11/29/2004
Charge
dumped to
bit line
Sense amp
decides 0
or 1
EE 42 fall 2004 lecture 37
time
18
DRAM/SRAM tradeoffs
• By it’s nature, DRAM isn’t built for speed
– Response time dependent on capacitive circuit
properties which get worse as density increases
• DRAM process isn’t easy to integrate into CMOS
process
– DRAM is off chip
– Connectors, wires, etc introduce slowness
– IRAM efforts looking to integrating the two
• Memory Architectures are designed to minimize
impact of DRAM latency
– Use dram for high density, store data which is used
often in smaller, higher speed SRAM cache.
11/29/2004
EE 42 fall 2004 lecture 37
19
FLASH Memory
• Floating gate transistor
– Presence of charge => “0”
– Erase Electrically or UV (EPROM)
• Performance
– Reads like DRAM (~ns)
– Writes like DISK (~ms). Write is a complex operation
11/29/2004
EE 42 fall 2004 lecture 37
20
More esoteric Storage
Technologies?
• Tunneling Magnetic Junction RAM (TMJ-RAM):
– Speed of SRAM, density of DRAM, non-volatile (no
refresh)
– New field called “Spintronics”: combination of
quantum spin and electronics
– Same technology used in high-density disk-drives
11/29/2004
EE 42 fall 2004 lecture 37
21
Tunneling Magnetic Junction
11/29/2004
EE 42 fall 2004 lecture 37
22