Transcript Slides - Agenda INFN

HYTEC ELECTRONICS LIMITED
Timing System Trigger Adapter Modules
Graham Cross
www.hytec-electronics.co.uk
Hytec’s 3000 series Adapter modules are
designed to convert low-level logic signals
normally generated by timing system modules
to the high level electrical and optical signals
demanded by accelerator and laser facilities
equipment.
Extremely low jitter system with (typically <10ps
rms) with fast rise times (<1ns).
Delay values increments in 50ps steps
.
The fully modular format allows conversion of
individual signals or a fan-out from one input to
a group of outputs.
The Adapters are stand-alone modules which plug
into a mains-powered chassis unit (RIM1809).
They can be used with a variety of timing
modules from different vendors.
One example is the range of timing system
modules (EVG, EVR, 4CHTIM) marketed by
Micro-Research Oy of Finland.
The fully modular format allows conversion of
individual signals or a fan-out from one input to a
group of outputs.
There are two basic module types;
• The 3020 - provides low level logic to electrical
output conversion
• The 3021 - provides logic to optical output
conversion.
1809 Chassis
Slots:
Power:
Monitor:
Dissipation:
Cooling:
Temperature:
Drift:
8 for Adapters, 2 for Power modules.
115VAC/230VAC dual selectable 47-63 Hz, IEC connector.
Power Fail provides logic level 1 indicating Power OK
200W max.
Convection or 1U fan-tray option air-cooled.
0 to 40 deg C ambient operating temperature.
Temperature variation should be restricted as far as possible.
3020 Electrical adapter
3020 Electrical
Input Connectors:
Four individual signal inputs (INP 1-4 – Lemo 00)
One common input (Fanout mode)
Inputs can be Low Level TTL, Low Level PECL (LVPECL) or CML
Output Connectors:
Four individual outputs (OP 1-4 – SMA)
One common out (Cascade mode – Lemo 00)
Amplitude:
Duration:
selectable.
Rise time:
Overshoot:
Jitter:
+5V or +30V (jumper selectable) into 50 ohms
1ns, 20ns (fixed) or >1us (externally controlled) jumper
500ps max for 5V 1ns pulse
1ns max for 30V 20ns pulse
100ns max for 5V 1us pulse
20% max for fast pulses, 10% for >1us pulses.
<10ps rms max input-output. (5ps rms typical)
COMMON OR SINGLE IP
SELECT
IP1+
IP1-
IP2+
IP2-
CHANNEL 1
PULSE
AMPLIFIER
OP1
CHANNEL 2
PULSE
AMPLIFIER
OP2
CHANNEL 3
PULSE
AMPLIFIER
OP3
0
CMN IP+
0
0
CMN IP-
0
0
FAN
OUT
IP3+
RECEIVER
IP3-
IP4+
CHANNEL 4
PULSE
AMPLIFIER
IP4-
OP4
OVERALL BLOCK DIAGRAM
BYPASS MODE
ENABLE 1ns SHAPING
+48VD
1ns
SHAPE
ENABLE 20ns MODE
0
0
0
0
0
0
0
0
0
0
MONO
SWITCH
(20NS)
SHAPER/
LIMITER
DRIVER
SEL 20/1NS
+5V
ENABLE >1us MODE
0
0
0
0
0
SWITCH
(>1US)
RECEIVER
PULSE AMPLIFIER BLOCK DETAIL
+48VD
+48V
REG-ADJ
SELECT 48V OR
VARIABLE
VOLTAGE SELECTION
SEL 1NS/1US
3021 Optical adapters
Type A 650nm
Type B 850nm
3021 Optical
Input Connectors:
Four individual signal inputs (INP 1-4 – Lemo 00)
One common input (Fanout mode)
Inputs can be Low Level TTL, Low Level PECL (LVPECL) or CML
Output Connectors:
Four individual optical outputs (OP 1-4 – ST connectors)
One common TTL out (Cascade mode – Lemo 00)
Wavelength:
Power O/P:
Width:
Risetime:
O/P Width:
Overshoot:
Jitter
3021A – 650nm
3021B – 850nm
1mW with internal attenuator
700uW max.
165ps at half height typical
1us nominal
90ps max.
100ps max.
180ps fixed (2.5ns I/P pulse)
1us to 100us variable
20% max.
20% max
<10ps rms
<50ns rms
BLOCK DIAGRAM OF TYPICAL TIMING SYSTEM OUTPUTS
50ps DELAY
RESOLUTION
10ps JITTER
PROGRAMMABLE
DELAY
RESOLUTION10ps
LVPECL TRIGGER 1
30V 20ns
LVPECL TRIGGER 2
4CH TIM FOUR CHANNEL
TIMER *
LVPECL TRIGGER 3
30V 20ns
3020A ELECTRICAL
ADAPTER
30V 20ns
30V 20ns
ETHERNET
CML CLK
CML
LVPECL TRIGGER 4
CML
HIGH LEVEL VOLTAGE
OUTPUTS
LOW RESOLUTION
5V OUTPUTS
CML
5V 1us
EVR230RF EVENT
RECEIVER *
TTL TRIGGER
3020C ELECTRICAL
ADAPTER/SPLITTER
5V 1us
ETHERNET
EVENT CLOCK
5V 1us
LOW RESOLUTION
OPTICAL TRIGGERS
850nm 1us
850nm 1us
EVR230RF EVENT
RECEIVER *
TTL TRIGGER
3021B OPTICAL ADAPTER/
SPLITTER
850nm 1us
ETHERNET
EVENT CLOCK
850nm 1us
MEDIUM RESOLUTION
10ps JITTER
CML TRIGGER 1
EVR230RF EVENT
RECEIVER *
CML TRIGGER 2
NARROW PULSE O/PS
650nm 150ps
3021A OPTICAL
ADAPTER
ETHERNET
CML TRIGGER 3
EVENT CLOCK
CML
5V 1us
* Micro-Research module
650nm 150ps
650nm 150ps
Application example

http://news.bbc.co.uk/1/hi/sci/tech/7656052.stm