Transcript The Electronics Kit

The Electronics
Kit
TEE2O1
Mr. Payne’s Period 5
Room S111
Contents of the Kit

Each group will be
responsible for
maintaining the
contents of 1 kit.
This is the Kit !
You should be able
to identify the
contents of each bag.
Make sure each bag
is kept separate from
other bags.
Note the unbagged:
Parallel Port Wire
1m
Wire strippers/cutters
1
Pliers 1
Wire - 5 colours
hookup wire 25'
The Electronics Kit

Identify the Parts in Each Bag
Bag One
110 ohm resistors 2
220 ohm resistors 16
1K ohm resistors 4
2K ohm resistors 1
LEDs (red) 16
LEDs (green) 2
LEDs (yellow) 2
1N4001 (transistor) 6
2.2uF capacitor 1

Resistors, LEDs, Transistors and
Capacitors
Bag Two

PN2222A 4
PN2907 4
1V-12V DC motor 1
stepper motor 1
DB25 Plastic Hood 1
DB25 D-sub
connector - crimping
style 1
Motors and 25 pin parallel port
connector kit.
Bag Three

10K ohm resistor 8
51K ohm resistor 1
100K ohm resistor 1
510K ohm resistor 1
1.5M ohm resistor 1
More Resistors
Bag Four

Male crimp pins 16
Wire - 5 colours
hookup wire 25
inches
Parallel Port Wire 1m
Wire for 25 pin connector
Bag Five

74LS194 - 4-bit Bidirectional shift
register 1
74LS154 - 4 to 16 deMultiplexer 1
Push button 8
Buttons and Integrated Circuits
Bag Six

74LS245 Transciever 1
74LS259 - 8 bit
addressable latch 2
555 - Timer 1
8 Segment Display and Integrated
Circuits
Bag Six

74LS00 - NAND 1
74LS02 - NOR 1
74LS04 - Inverter 1
74LS08 - AND 1
74LS32 - OR 1
74LS47 - 7- Segment
decoder/driver 1
74LS74 - Dual D flipflop 1
74LS86 - XOR 1
More Integrated Circuits
The Big Cahuna

The electronic
experimenter box is
where you provide
power and ground to
your circuits.
The Power Board and Switches
and Input / Output Lights
See the upcoming Powerpoints on Labs 4.2.1 and 4.2.2
How It Works
How It Works
Next Steps



Be sure that you know where all
parts belong before you use them
to make circuits.
Remember to replenish your kit for
the next class!
A full parts list for the kit is
available at
http://www.classictechnology.ca/